POWER SUPPLY 230V. It must not be connected
to D.C. mains.
Note: The mains lead of the set is fitted with a
moulded plug. If the mains socket are not
compatible or if for any reason the plug is
removed please follow the directions below. The
moulded plug cannot be rewired and if removed
must be disposed of safely.
DO NOT under any circumstances plug the
severed plug into any mains socket as this could
result in electric shock.
Important: If the plug is removed, rewire the
new plug as follow:
The wires in the mains plug are coloured in
accordance to the following code:
BLUE = NEUTRAL/BROWN = LIVE
If the colours of the wires in the mains lead of
this apparatus may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
BLUE wire to the terminal coded N (Neutral) or
coloured black.
BROWN wire to the terminal coded L (Live) or
coloured red.
DO NOT make any connection to
the terminal in the plug which is
marked
by the letter E or by the earth
symbol or coloured green or
green and yellow.
A fused plug must be
fitted with a 3A fuse
approved by ASTA or
BS1362 and fuse covers
must be always be
securely replaced. If
you set does not work,
the fuse may be
blown.
CS104 EN3/8/04, 1:46 PM2
CAUTION
RISK OF ELECTRIC SHOCK
THE LIGHTNING
FLASH AND ARROWHEAD WITHIN THE
TRIANGLE IS A
WARNING SIGN
ALERTING YOU OF
"DANGEROUS
VOLTAGE" INSIDE
THE PRODUCT.
SEE MARKING ON BOTTOM / BACK OF PRODUCT
WARNING:
SHOCK HAZARD,
TO RAIN OR MOISTURE.
DO NOT OPEN
CAUTION: TO REDUCE THE
RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER
(OR BACK). NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE
PERSONNEL.
TO PREVENT FIRE
DO NOT EXPOSE THIS PRODUCT
THE EXCLAMATION
POINT WITHIN THE
TRIANGLE IS A
WARNING SIGN
ALERTING YOU OF
IMPORTANT
INSTRUCTIONS
ACCOMPANYING
THE PRODUCT.
OR ELECTRICAL
Safety Information
CAUTION!
Invisible laser radiation when open. Avoid
exposure to beam. Class 1 laser product. This
system must be opened only by qualified
technicians to prevent accidents caused by the
laser beam.
LASER λ = 780 nm, P max = 5 mW
Rating Information: At bottom/rear of the unit.
This unit comply with the existing requirements
In accordance with the rating plate
of the unit, this unit complies with
current standards concerning
electrical safety and
electromagnetlc compatibillity.
Please respect the environment.
Before throwing any batteries
away, consult your distributor who
may be able to take them back for
specific recycling.
Have a Blast- Just Not in Your
Eardrums!
Make sure you turn down the
volume on the unit before you put
on headphones. Increase the
volume to the desired level only
after headphone are in place.
CAUTION – INVISIBLE LASER RADIATION
WHEN OPEN AND INTERLOCKS FAILED OR
DEFEATED. AVOID EXPOSURE TO BEAM.
RAYONNEMENT LASER INVISIBLE
ATTENTION –
DANGEREUX EN CAS D'OUVERTURE ET LORSQUE
LA SECURITE EST NEUTRALISEE.
EXPOSITION DANGEREUSE AU FAISCEAU.
ADVARSEL!
USYNLIG LASERSTRĀLING, NĀR ENHEDEN ER ĀBEN
OG SIKKERHEDSAFBRYDERNE ER UDE AF
FUNKTION ELLER OMGĀET. UNDGĀ EKSPONERING
FOR STRĀLEN.
VORSICHT!
UNSICHTBARE LASERSTRAHLUNG BEI GEÖFFNETER
ABDECKUNG, FALLS SICHERHEITS-VERRIEGELUNG NICHT
EINGERASTET IST ODER WENN SIE BEEINTRÄCHTIG
IST. SETZEN SIE SICH NICHT DEM LASERSTRAHL AUS!
CLASS 1 LASER PRODUCT
LASER KLASSE 1
LASERAPPARAT AV KLASS 1
AREIL A LASER
LUOKAN 1 LASERLAITE
LASERPRODUKT AF KLASSE 1
VARNING!
OSYNLIG LASERSTRĀLNING NÄR DENNA
DEL ÄR ÖPPNAD OCH SPÄRRARNA ÄR
URKOPPLADE. TITTA EJ IN I STRĀLEN.
VARO
AVATTAESSA JA OHITETTAESSA SUOJALUKITUS
OLET ALTTIINA NÄKYMÄTTÖMÄLLE
LASERSÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN.
DE
CLASSE 1
EN
The descriptions and characteristics in this owner’s manual are for the purpose of general reference only and not as a
guarantee. In order to provide you with the highest quality product, we may make changes or modifications without
prior notice. The English version serves as the final reference on all product and operational details should any
discrepancies arise in other languages.
CS104 EN3/8/04, 1:46 PM3
Table of Content
Safety Information
EN
Getting Started .................................. 2
Unpacking Your System ................................... 2
To ensure sufficient ventilation, keep the spacing
shown as below:
Front View
10cm
ON•ECO
IR SENSOR
TIMER
MULTI FUNCTION LCD DISPLAY
DIGITAL PLL SYNTHESIZED TUNER
DIGITAL LOGIC DECK
PLAYBACK/ RECORD
10cm
CD
TUNING
U
M
L
O
E
V
C
L
O
O
N
R
T
10cm
OPEN/
CLOSE
Connecting the Speakers
When connecting the speakers, match the red
wires to the red jacks and the black wires to the
black jacks. Each speaker has a black and a red
jack, one for positive and one for negative. The
top two jacks are for the left speaker, while the
bottom two jacks are for the right speaker.
R
Speaker
NOTE: Make sure the insulation
Wire Connection
Push Speaker terminal tab
down to insert wire.
speaker wires at all connection
ends of the
Release tab to lock wire in
the terminal.
is completely removed from the
L
points.
EN
Side View
10cm
5cm
CS104 EN3/8/04, 1:46 PM5
Using the Antenna
Before you use your audio system, you’ll want to
make sure the FM antenna is positioned properly.
The FM antenna is the coiled wire connected to
the back of the unit. Uncoil it, making sure it is
fully extended (you may even want to tape it to
the wall behind the unit, if possible. The higher,
the better.)
For better AM reception, move or rotate the unit.
2
General Controls
EN
ON•ECO
IR SENSOR
TIMER
MULTI FUNCTION LCD DISPLAY
DIGITAL PLL SYNTHESIZED TUNER
DIGITAL LOGIC DECK
PLAYBACK/ RECORD
Front View
CD
TUNING
U
M
L
O
E
V
C
L
O
O
N
R
T
OPEN/
CLOSE
ON•ECO – Turns on/off the unit. Remember to
unplug the power cord from the power outlet if
you are not going to use the system for some time.
Press and hold to enter ECO mode. In ECO mode,
the power consumption is below 3W.
CD – Selects CD mode.
TUNER/BAND•APP – Selects tuner mode; selects
radio band in tuner mode; begins auto preset
programming.
TAPE – Selects tape mode.
CLOCK•TIMER – Shows clock time and timer on/
off time; enters clock and timer setting mode;
enable or disable timer mode.
PRESET - / + – In tuner mode – selects preset
station.
PROG•SET•CLEAR – Enters program setting mode;
confirms your settings; clears settings.
REC•II – Starts/pauses recording from CD / Tuner
mode.
RDS - In Tuner mode - Shows RDS information in
FM broadcast (station name (RT), station type (PTY)
and clock time (CT)).
EQ – Selects among different sound effects (flat /
classic / rock / pop / jazz).
X-BASS – Enables / disables X-Bass
PLAY/PAUSE ( ) – In CD mode – Plays and
pauses CD playback.
In Tape mode – Plays and pauses tape playback.
STOP ( ) – In CD mode - Stops CD playback.
In Tape mode – Stops tape playback.
TUNING - / + (SKIP BACKWARD / SKIP
FORWARD ) – In CD mode - skips backward or
forward to the other tracks.
In Tape mode - Rewinds or fast forwards tape.
In tuner mode -searches down or up radio
frequency.
VOLUME CONTROL – Adjusts the sound level.
3
CS104 EN3/8/04, 1:46 PM6
Top View
OPEN/CLOSE – Press to open the CD compartment
door.
PHONES – Jack for connecting headphones.
Loading...
+ 10 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.