Distribution and copying of this document, use and communication of its contents is not permitted without written authorization
from Thomson. The content of this document is furnished for informational use only, may be subject to change without notice,
and should not be construed as a commitment by Thomson. Thomson assumes no responsibility or liability for any errors or
inaccuracies that may appear in this document.
The following trademarks may be used in this document:
>DECT is a trademark of ETSI.
>Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc.
>Ethernet™ is a trademark of Xerox Corporation.
>Wi-Fi®, WMM® and the Wi-Fi logo are registered trademarks of the Wi-Fi Alliance®. "Wi-Fi CERTIFIED", "Wi-Fi ZONE",
"Wi-Fi Protected Access", "Wi-Fi Multimedia", "Wi-Fi Protected Setup", WPA", WPA2" and their respective logos are trademarks of the Wi-Fi Alliance®.
>UPnP™ is a certification mark of the UPnP™ Implementers Corporation.
>Microsoft®, MS-DOS®, Windows®, Windows NT® and Windows Vista® are either registered trademarks or trademarks
of Microsoft Corporation in the United States and/or other countries.
>Apple® and Mac OS® are registered trademarks of Apple Computer, Incorporated, registered in the United States and
other countries.
>UNIX® is a registered trademark of UNIX System Laboratories, Incorporated.
>Adobe®, the Adobe logo, Acrobat and Acrobat Reader are trademarks or registered trademarks of Adobe Systems, Incor-
porated, registered in the United States and/or other countries.
Other brands and product names may be trademarks or registered trademarks of their respective holders.
Document Information
Status: v1.0 (June 2008)
Reference: E-DOC-CTC-20080421-0002
Short Title: Setup and User Guide TG782 R8.1 (en)
Contents
About this Setup and User Guide ............................................. 1
8.3Voice over IP Troubleshooting...................................................................... 64
8.4Reset to Factory Defaults ............................................................................. 65
ii
E-DOC-CTC-20080421-0002 v1.0
About this Setup and User Guide
About this Setup and User Guide
Used Symbols
A note provides additional information about a topic.
A caution warns you about potential problems or specific precautions that need to be taken.
Terminology
Generally, the THOMSON TG782 will be referred to as Thomson Gateway in this Setup and User Guide.
Typographical Conventions
Following typographical convention is used throughout this manual:
Sample text indicates a hyperlink to a Web site.
Example: For more information, visit us at www.thomson-broadband.com
Sample text indicates an internal cross-reference.
Example: If you want to know more about guide, see “1 Introduction” on page 7”.
Sample text indicates an important content-related word.
Example: To enter the network, you must authenticate yourself.
Sample text indicates a GUI element (commands on menus and buttons, dialog box elements, file
names, paths and folders).
Example: On the File menu, click Open to open a file.
.
Documentation and software updates
Thomson continuously develops new solutions, but is also committed to improving its existing products.
For more information on Thomson's latest technological innovations, documents and software releases, visit
us at http://www.thomson-broadband.com
.
E-DOC-CTC-20080421-0002 v1.0
1
About this Setup and
User Guide
2
E-DOC-CTC-20080421-0002 v1.0
1 Installation
1Installation
Introduction
In a few minutes you will be able to access the Internet using your Thomson Gateway.
This Setup and User Guide will show you how to set up your Thomson Gateway and how to connect your
computer(s) to the Internet.
E-DOC-CTC-20080421-0002 v1.0
3
1 Installation
1.1Preliminary Steps
DSL service
The DSL service must be up and running on your telephone line.
If both conventional telephone and DSL service are simultaneously available from the same copper pair, you
will need a central splitter or distributed filters for decoupling DSL and telephone signals.
Public telephone lines carry voltages that can cause electric shock. Only try to set up splitter/
filters that have been designed to be installed by unqualified personnel. For further assistance,
contact your Internet Service Provider.
Computer requirements
To connect a computer via Ethernet, make sure the computer is equipped with an Ethernet Network
Interface Card (NIC).
For wireless networking, you will need a WiFi-certified wireless client adapter for each computer you
want to connect wirelessly.
Internet connection details
You may need the following connection details from your Internet Service Provider (ISP):
Your ISP’s method for connecting to the Internet (for example PPPoE)
The VPI/VCI (for example 8/35)
Your user name and password to connect to the Internet for PPP connections
Your IP settings in case of static configurations
Optionally your ISP may indicate the Service Profile to use during Setup.
You may have received this information when you subscribed at your Internet Service Provider. You may be
prompted for this information at a given step in the installation procedure.
Voice over IP (VoIP) connection details
If you want to be able to make phone calls over the Internet, you will need following details for your VoIP
connection:
A user account at your VoIP Service Provider
The server settings of your VoIP Service
These settings may be provided by your Internet Service Provider.
4
E-DOC-CTC-20080421-0002 v1.0
1 Installation
1.2Installing your Thomson Gateway
Installation methods
There two ways to set up your Thomson Gateway:
Guided Installation
Manual Installation
Guided Installation
How it works
The Setup wizard included on the CD will guide you through all configuration aspects of your Thomson
Gateway. This is the recommended way to install your Thomson Gateway.
Requirements
Your computer must run one of the following operating systems:
Microsoft Windows Vista (SP1) or higher
Microsoft Windows Vista x64 (SP1) or higher
Microsoft Windows XP Service SP2 or higher
Microsoft Windows XP x64 SP 1 or higher
Microsoft Windows 2000 SP4
Mac OS X 10.4 (Tiger)
Mac OS X 10.5 (Leopard)
You must have administrative rights on your computer
Getting started
Proceed with“1.2.1 Guided Installation” on page 6.
Manual Installation
How it works
The Setup and User Guide will first help you to connect your computer to the Thomson Gateway. After this is
done, you can configure your Thomson Gateway using your web browser.
Requirements
Javascript must be enabled on your web browser.
Getting started
Proceed with“1.2.2 Manual Installation” on page 8.
E-DOC-CTC-20080421-0002 v1.0
5
1 Installation
1.2.1Guided Installation
Connecting devices: wait!
Do not plug in any cables or connect any devices until you are prompted to do so by the wizard.
In case of problems
If you encounter problems during this installation please refer to “8.1 Setup wizard Troubleshooting” on
page 60.
Starting the wizard
To start the wizard:
1Insert the Setup CD into your computer's CD- or DVD-ROM drive.
2If your computer runs:
Microsoft Windows: The CD should autostart.
Mac OS X: Double-click Menu in the window with the content of the CD.
3Select the language of your choice and click OK.
4The Setup wizard will now guide you through the installation.
5At the end of the installation, following screen appears:
6Select the Go to the Thomson Gateway Web Interface
Interface after closing the wizard. On the Thomson Gateway Web Interface, you can further configure
your Thomson Gateway.
7Click Finish.
8The CD menu appears.
6
if you want to go to the Thomson Gateway Web
E-DOC-CTC-20080421-0002 v1.0
CD menu
1 Installation
On the CD Menu, click:
Initial Setup to connect your computer to the Thomson Gateway and configure it.
Reconfigure my Thomson Gateway to reconfigure your Thomson Gateway.
Setup my computer to connect your computer to the Thomson Gateway network.
View Documentation to view the documentation that is available for your Thomson Gateway. This list
will be automatically updated if you are connected to the Internet.
Visit Thomson Broadband to visit the online support sections on www.thomson-broadband.com.
Actual available items may depend on the Setup CD delivered with your Thomson Gateway.
E-DOC-CTC-20080421-0002 v1.0
7
1 Installation
1.2.2Manual Installation
Procedure
Proceed as follows:
1Connect the cables
2Configure the Thomson Gateway
Connect the cables
Proceed as follows:
1Connect your computer to the Thomson Gateway as described in “3 Adding a New Computer to your
Network” on page 19.
2Connect the Thomson Gateway to the DSL line.
3Connect the power supply.
4Turn on the Thomson Gateway.
Configure the Thomson Gateway
1Open your web browser.
2The Thomson Gateway informs you that you have not yet configured your Thomson Gateway.
If this window does not appear browse to http://dsldevice.lan
Gateway (by default: 192.168.1.254) and click Thomson Gateway on the menu on the left-hand side.
3Click Setup my Thomson Gateway.
4The Easy Setup wizard appears. This wizard will guide you through the configuration of your Thomson
Gateway. Click Next and follow the instructions.
or to the IP address of your Thomson
8
E-DOC-CTC-20080421-0002 v1.0
2Thomson Gateway Basics
In this chapter
Thomson Gateway LED Behaviour10
Thomson Gateway Web Interface15
Backing Up/Restoring your Configuration18
2 Thomson Gateway Basics
Topi cPage
E-DOC-CTC-20080421-0002 v1.0
9
2 Thomson Gateway
Basics
2.1Thomson Gateway LED Behaviour
Content
This chapter describes the behaviour of:
Status LEDs
WPS Button LED
Ethernet LEDs
10
E-DOC-CTC-20080421-0002 v1.0
2 Thomson Gateway Basics
2.1.1Status LEDs
Introduction
On the front panel of your Thomson Gateway, you can find a number of status LEDs, indicating the state of
the device during normal operation.
Power LED
ColourStateDescription
GreenSolid onPower on, normal operation
RedSolid onPower on, self-test failed, indicating device malfunction
The WPS button allows you to add new wireless clients to your network.
For more information, see Connecting Your Wireless Client via WPS.
WPS LED
ColourStateDescription
GreenSolid OnClient successfully registered via WPS
AmberBlinkingWPS registration ongoing
RedBlinking Error occurred
E-DOC-CTC-20080421-0002 v1.0
13
2 Thomson Gateway
2.1.3Ethernet LEDs
Ethernet LED
A LED may be provided per Ethernet port to indicate link integrity (or activity).
LED StatusDescription
OffNo connection on this port
Solid onEthernet link up
BlinkingData is flowing from/to this port
Basics
14
E-DOC-CTC-20080421-0002 v1.0
2 Thomson Gateway Basics
2.2Thomson Gateway Web Interface
Introduction
The Thomson Gateway Web Interface allows you to configure your Thomson Gateway using your web
browser.
Requirements
Javascript must be enabled on your browser. For more information, consult the help of your Internet
browser.
Accessing the Thomson Gateway Web Interface
Proceed as follows:
1Open your web browser.
2Browse to http://dsldevice.lan
3If you have protected your Thomson Gateway with a user name and password, the Thomson Gateway
will prompt you to enter these. Enter your user name and password and click OK.
4The Thomson Gateway Web Interface appears.
If your computer runs Windows Vista or Windows XP, you can also access the Thomson Gateway Web
Interface using the Internet Gateway Device icon. For more information, see “6.1 Universal Plug and Play” on
page 43.
or to the IP address of your Thomson Gateway (by default: 192.168.1.254).
E-DOC-CTC-20080421-0002 v1.0
15
2 Thomson Gateway
Components
All the pages contain following components:
2
1
Basics
3
4
5
6
LabelDescription
1Menu
2Language Bar
3Navigation Bar
4Notification Area
5Content pane
6Tasks
Menu
The menu is located on the left side of the page and consists of the following menu items:
Thomson Gateway:
Provides basic information on the Thomson Gateway.
Broadband Connection:
Allows you to view/configure your broadband connections.
Toolbox:
Allows you to assign games or applications to a device and secure your Internet connection.
Home Network:
Allows you to manage your local network.
16
Language Bar
The language bar is located in the top banner and allows you to change the language of the Thomson
Gateway Web interface.
The language bar will only be shown if more than one language is available.
E-DOC-CTC-20080421-0002 v1.0
2 Thomson Gateway Basics
Navigation Bar
The navigation bar is located at the top of the page and allows you to:
View the current user name.
Click this name to change your password or switch to another user.
View the current position in the Thomson Gateway Web interface.
Select change the display level of the page (for example: Overview, Details or Configure)
Get context-related Help information.
Notification Area
The notification area is located under the Navigation Bar and is used to display:
Error messages, indicated by a red traffic light.
Warnings, indicated by an orange traffic light.
Information, indicated by a green traffic light.
If none of these events occur, the notification area will not be shown.
Content pane
The content pane is located at the centre of the page and displays the information and configurable items of
the selected topic.
Tas ks
To allow a quick configuration of your Thomson Gateway, some pages may offer you a number of related
tasks in the Pick a task list. These tasks will guide you to the page where you can perform the selected task.
E-DOC-CTC-20080421-0002 v1.0
17
Loading...
+ 51 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.