Technicolor Delivery Technologies Belgium TG585V8 User Manual

Safety Instructions and Regulatory Notices 3

Read this document prior to installation!

Consignes de Sécurité et Informations Réglementaires 9

Lisez ce document avant d’effectuer l’installation!

SAFETY INSTRUCTIONS AND REGULATORY NOTICES

BEFORE YOU START INSTALLATION OR USE OF THIS PRODUCT, CAREFULLY READ THESE INSTRUCTIONS

When using this product, always follow the basic safety precautions to reduce the risk of fire, electric shock and injury to persons, including the following:

> Always install the product as described in the documentation that is included with your product. > Avoid using this product during an electrical storm. There may be a remote risk of electric shock from

lightning.

> Do not use this product to report a gas leak in the vicinity of the leak.

Wireless

In case this product is equipped with a wireless transceiver, it uses Direct Sequence Spread Spectrum (DSSS) / Orthogonal Frequency Division Modulation (OFDM) radio technology. As such it is designed to be inter-operable with any other wireless DSSS/OFDM type product that: > Complies with the IEEE802.11b/IEEE802.11g/IEEE802.11n Standard on Wireless LANs, as defined and approved

by the Institute of Electrical and Electronics Engineers.

> Is Wi-Fi® CERTIFIED™ as defined by the Wi-Fi® Alliance.

Directive

Unless express and prior approval by THOMSON in writing, you may not: > Disassemble, de-compile, reverse engineer, trace or otherwise analyse the equipment, its content, operation, or

functionality, or otherwise attempt to derive source code (or the underlying ideas, algorithms, structure or organization) from

the equipment, or from any other information provided by THOMSON, except to the extent that this restriction is expressly

prohibited by local law;

> Copy, rent, loan, re-sell, sub-license, or otherwise transfer or distribute the equipment to others; > Modify, adapt or create a derivative work of the equipment; > Remove from any copies of the equipment any product identification, copyright or other notices; > Disseminate performance information or analysis (including, without limitation, benchmarks) from any source

relating to the equipment. Such acts not expressly approved by THOMSON will result in the loss of product warranty and may invalidate the user's authority to operate this equipment in accordance with FCC Rules. THOMSON disclaims all responsibility in the event of use that does not comply with the present instructions.

Environmental information - WEEE directive

This symbol means that your inoperative electronic appliance must be collected separately and not mixed with the household waste.The European Union has implemented a specific collection and recycling system for which producers are responsible.

This appliance has been designed and manufactured with high quality materials and components that can be recycled and reused.

Electrical and electronic appliances are liable to contain parts that are necessary in order for the system to work properly but which can become a health and environmental hazard if they are not handled or disposed of in the proper way. Consequently, please do not throw out your inoperative appliance with the household waste.

If you are the owner of the appliance, you must deposit it at the appropriate local collection point or leave it with the vendor when buying a new appliance.

> If you are a professional user, please follow your supplier's instructions. > If the appliance is rented to you or left in your care, please contact your service provider.

Please help us protect the environment in which we live!

Safety Instructions

Climatic conditions

This product: > Is intended for in-house stationary desktop use; the maximum ambient temperature may not exceed 40°C

(104°F).

> Must not be mounted in a location exposed to direct or excessive solar and/or heat radiation. > Must not be exposed to heat trap conditions and must not be subjected to water or condensation. > Must be installed in a Pollution Degree 2 environment (Environment where there is no pollution or only dry,

nonconductive pollution).

Cleaning

Unplug this product from the wall socket and computer before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

Water and moisture

Do not use this product near water, for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement or near a swimming pool. Transition of the product from a cold environment to a hot one, may cause condensation on some of its internal parts. Allow it to dry by itself before re-starting the product.

Interface classifications

The external interfaces on the rear panel of the product are classified as follows:

> DSL, ADSL, SHDSL, VDSL, Line: TNV circuit, subjected to over voltages (TNV-3) > ISDN: SELV circuit > PSTN, FXO: TNV circuit, subjected to over voltages (TNV-3)

> Phone, VoIP, FXS: TNV circuit, not subjected to over voltages (TNV-2)

WARNING > The Phone, VoIP, FXS port will be classified as a TNV-3 circuit when connected internally to the PSTN,

FXO port, for example, when the device is powered off.

> If the product is equipped with a USB interface (slave and/or master) or any type of connector with

metallic shielding, then it is not allowed to connect the Phone, VoIP, FXS port with the PSTN, FXO or the DSL, ADSL, SHDSL, VDSL, Line port by any means, for example with an external telephone cable.

> All other interface ports (e.g. Ethernet, 10/100Base-T/MDI(-X), USB, Console, Craft, etc.), including the low

voltage power input from the AC mains power supply: SELV circuits.

Electrical powering

The powering of the product must adhere to the power specifications indicated on the marking labels. The power supply must be Class II and a Limited Power Source in accordance with the requirements of IEC60950-1/

EN60950-1, Clause 2.5 and rated as indicated on the label on your product. It must be tested and approved to national or local standards. For US and Canada: This product is intended to be supplied by a Listed Direct Plug-in, or Desktop Power Unit marked "Class 2" and rated as indicated on the label on your product. The use of other types of supplies is prohibited. If you are not sure of the type of power supply needed, consult the product's user documentation or contact your local product dealer.

ISDN

WARNING For US and Canada: Do not use the ISDN port; do not attempt to connect this port to the network at

anytime.

USB

The device is to be connected to an identified USB port complying with the requirements of a Limited Power Source.

Telephone cable

CAUTION: To reduce the risk of fire, use only No 26 AWG wire size or larger telecommunication line cord. Connect the telecommunication line cord only in the PSTN, FXO, DSL, ADSL, SHDSL, VDSL or Line port of the

product. Never plug the telecommunication line cord in another receptacle of the product. Follow the installation instructions in the sequence as outlined in the installation guide.

Central splitter / distributed filter(s) (if applicable)

If telephone service is required on the same line, a central splitter or distributed filter(s) must be installed for optimal DSL performance.

Depending on your DSL configuration and type of splitter / filters, installation must be carried out by qualified service personnel. Consult your telephone service company or DSL service provider for instructions.

Accessibility

The Direct Plug-in power supply, or the plug on the power supply cord serves as disconnect device. Be sure that the power socket outlet you plug the power supply into is easily accessible and located as close to the equipment as possible.

+ 11 hidden pages