Technicolor Delivery Technologies Belgium TG389ACHP User Manual
1. Before you start
B C
A
Carefully read the Safety Instructions and Regulatory Notices booklet included in the box before
continuing with the installation of the MediaAccess Gateway.
2. Check the content of your box
QUICK INSTALLATION GUIDE
MediaAccess TG389ac
D
E
Your box contains the following items:
Item Description
A One MediaAccess TG389ac.
In this document we will refer to it as MediaAccess Gateway.
B This Quick Installation Guide.
C One Safety Instructions and Regulatory Information booklet.
D One power adapter.
E One Ethernet cable with yellow connectors.
F One Ethernet cable with red connectors.
F
3. Install your MediaAccess Gateway
3
4
Wireless key: **************
Network Name: **************
WPS
Network Name
4
3
WAN
21
IAD
Connect the MediaAccess Gateway to your Internet Access Device (IAD)
1 Take the Ethernet cable with the red connectors.
2 Connect one end of the Ethernet cable to the red port (WAN) on your
MediaAccess Gateway.
3 Connect the other end of the Ethernet cable to your Internet access device (for example, an
optical network terminal, a DSL/cable modem, etc.).
Power on the MediaAccess Gateway
1 Plug the connector of the electric power supply adapter into the MediaAccess Gateway
power inlet port.
2 Plug the adapter into a nearby power outlet.
3 Press the power button ( ) on the back panel. After a few minutes:
The Power LED on the front panel must be solid green.
If this is not the case, check the connections that you made in the previous steps.
If the Power LED is blinking green or orange, the MediaAccess Gateway is
updating its software. If this is the case, wait until the Power LED becomes solid
green. This can take several minutes! Do not power o your device or unplug any
cables!
The Internet LED on the front panel must be solid green.
If this is not the case, check the connections that you made in “Connect the to the
Internet” or contact your service provider (if the broadband service is not enabled yet).
Loading...