Page 1
Technaxx® * User Manual
LED Outdoor Lamp TX-107
The Declaration of Conformity for this device is under the Internet link:
www.technaxx.de/ (in bottom bar “Konformitätserklärung”). Before using the
device the first time, please read the user manual carefully.
Service phone No. for technical support: 01805 012643 (14 cent/minute from
German fixed-line and 42 cent/minute from mobile networks).
Free Email: support@technaxx.de
If you drill a hole in the wall, please make sure that power cables, electrical
cords and/or pipelines are not damaged. When using the supplied mounting
material, we do not take the liability for a professional installation. You are
entirely responsible to ensure that the mounting material is suitable for the
particular masonry, and that the installation is done properly. Also ensure that
the mounting place is strong enough to hold this heavy device. When working
at higher altitudes, there is danger of falling! Therefore, use suitable
safeguards.
Keep this user manual for future reference or product sharing carefully. Do
the same with the original accessories for this product. In case of warranty,
please contact the dealer or the store where you bought this product.
Warranty 2 years
Enjoy your product * Share your experience on Amazon
Features
LED light with 250 lumen brightness (3.3W) up to ~8m distance
(open areas) & luminous time ~20 seconds
PIR motion detection of 120° angle up to ~7m (open areas)
PIR trigger time 0.6 seconds
Stand alone device powered by batteries
Wall mounting (360° rotation, 180° up/down)
Many other mounting possibilities e.g. in the garden with the
ground mounting holder
Protection class IP65 (dust & waterproof)
Page 2
Technical specifications
PIR
max. distance ~7m / angle 120° / trigger time 0.6
seconds
distance ~8m / power 3.3W, 250 lumen (25W
Light
incandescent bulb) / Colour: 6000–6500 Kelvin
4x D-cell alkaline batteries* 1.5V
Power supply
[*not included, not rechargeable]
Ø duration
Light mode 10x at night ~8 month
battery life
Operation temperature –10°C up to +50°C
Weight / Dimensions 330g / (L) 19.5 x (W) 15.0 (H) 10.5 cm
Package
Contents
LED Outdoor Lamp TX-107, 1x Ground mounting
holder, 3x Screws with dowels, User Manual
Note: These parts are needed to operate but are not included.
4x D-Alkaline batteries
Security and Disposal Hints for Batteries: Hold children off
batteries. When a child swallowed a battery go to a doctors
place or bring the child into a hospital promptly! Look for the
right polarity (+) and (–) of batteries! Always change all batteries.
Never use old and new batteries or batteries of different types
together. Never short, open, deform or load up batteries! Risk
of injury! Never throw batteries into fire! Risk of explosion!
Hints for Environment Protection: Packages materials are
raw materials and can be recycled. Do not disposal old devices
or batteries into the domestic waste. Cleaning: Protect the
device from contamination and pollution (use a clean drapery).
Avoid using rough, coarse-grained materials or
solvents/aggressive cleaner. Wipe the cleaned device
accurately. Distributor: Technaxx Deutschland GmbH & Co.KG,
Kruppstr. 105, 60388 Frankfurt a.M., Germany
Page 3
Product overview
1 PIR 4 Angle adjustment
2 LED light 5 Mounting base thumb
3 Mounting base
How to use the lamp
A.1 A.2
B.1 B.2
Remove the front
cover by rotating
counter-clockwise
picture A.1 and A.2.
Open the lock picture B.1.
Insert 4D-Cell batteries
picture B.2.
Note: Install batteries with
polarity in correct position.
Page 4
C.1
By removing the screw 2, you can
remove the head from the mounting
base for angle adjustments.
C.2
C.3
Hold the base to the installation
surface and mark the screw holes
with a pencil.
Hold the base to the surface you
want to install it on mark the screw
holes with a pencil drill holes on
the marks into the wall insert the
dowels drive screws through the
holes of the mounting base.
Attention: asure that you use the
correct dowels for your desired
surface the dowels in the package
D.1
contents are for normal concrete
walls.
Put back the front cover. Important:
the arrows must match.
turn the front cover to close it
correctly (tighten the weatherproof
seal)
Page 5
D.2
Put the head back on the basis
tighten the screw 2
E.1
E.2
Loosen the screw 1 (little by little)
turn the device to the right position
(max. 360° around)
tighten the screw 1
Loosen the screw 2 (little by little)
bend the device to the right
postion (max. 180°)
tighten the screw 2
Mode Light
Light Mode
Note: Use only new alkaline D-Cell
batteries with 1.5V rating. Do not mix
old and new batteries. Install
batteries with polarity in correct
position
Page 6
ON Mode
After inserting the batteries the light mode is turned on and will be
activated automatically when movement is triggered. Light shuts off
after 20 seconds if there is no more movement. If during 20
seconds there is still movement the light will continue shining for 20
seconds. Light goes on only in darkness to conserve battery life.
TURN OFF Mode
The device does not have a separate OFF mode. Only by removing
the batteries you can deactivate the device.
PIR detecting range
Remark: The PIR detecting range is different for different people.
Moreover, the PIR detecting range is affected by the environment
temperature (25°C is the best temperature).
Distance 1.5m
120° detection angle
Distance 3.5m
90° detection angle
Distance 7m
30° detection angle
Ground Mounting holder
With the ground mounting holder* (*included) you can you use the
device as path light or as path light in your garden.
Page 7
Long
There are several variables that will determine the battery life (type
of batteries, temperature outside, frequency of activity, etc.)
Different brands of batteries may also perform better than others, so
please experiment to find what works best for you.
Middle values for battery life
Battery Life
is one of the most important requirements.
Light mode 10 times at night
(~3 minutes with average brand alkaline)
Light mode 10 times at night
(~3 minutes with top brand alkaline)
up to 6 month
up to 8 month
WARNINGS
(To reduce the risk of fire, electrical shock or product damage/failure)
Do not expose unit with the rear cover open to rain, moisture,
dripping or splashing. Do not open or close the battery door with
wet hand. Completely wipe off water on unit and door before
opening. Do not submerge product in water(this unit is designed
for normal outdoor use). Only use batteries as specified in this
user manual and install according to correct polarization. Failure to
follow may result in leaking or exploding batteries, damage to
product, fire or personal injury. Do not handle damaged or leaking
batteries. Do not expose to extreme heat. Do not leave product
and/or batteries exposed in direct sunlight inside a vehicle, or other
contained environment for a long period of time. Only use
accessories as recommended in this manual.
TECHNAXX recommends using 4 pieces of D-Size Alkaline
batteries of very high standard, this product can model to obtain
maximum battery life (do not mix old and new batteries).
Rechargeable batteries are NOT recommended.
Loading...