Technaxx Musicman BT-X5 User guide

MusicMan® BT Dongle

User Manual

Please find the Declaration of Conformity for this device under following internet-link:

www.technaxx.de/konformitaetserklaerung/musicman_bt_dongle

Read the instructions carefully before using the device.

Charge the battery about 3–5 hours before using the device the first time.

Features

 Support routes calls and music from a smartphone through car speakers
 Seamlessly switches between calls and music
 Bluetooth 3.0 + EDR for superior wireless performance
 Built-in high performance stereo audio codec
 Supports HSP (Headset Profile), HFP (Hands-Free Profile), A2DP (Advanced Audio Distribution

Profile), AVRCP (Audio / Video Remote Control Pofile)

 Supports AUX-IN when connected to car stereo
 Embedded microphone mounts anywhere on the dashboard for the best voice pick-up

Accessories: Micro USB charging cable, 3.5mm – 3.5mm phone jack cable, User Manual

1

Function Table

LED STATUS

RED light Charging
Flashing RED light Low batterie
Steady BLUE light Playing or pairing done
Steady PURPLE light BT music is connecting status for charging
Rapid flashes of BLUE light Searching previous pairing
Slow flahes of BLUE light Searching new pairing / Incoming phone call
First flashing PURPLE then BLUE light of flicker Power ON
RED and BLUE light of flicker interlace Power OFF

FUNCTION OPERATION

Control Button

Micro USB port

Reset
Power ON / OFF

When playing music

Tap to button  Pause
Tap to button again  Playing
Double tap the button  Playing the next song

When phone incoming call

Tap to button  answer call
Tap to button again  End call
When device does not find pair, or you go away more then
10m in distance for 2 minutes, device will go to Standby mode
 Press and hold button, then it works again
When RED light flashes  Low battery
You have to plug in the Micro USB charging cable and charge
directly from your PC

When light is RED  Device is charging
When RED light went off  Device is fully charged
Reset power

Press ~5 sec. the power button until LED slow BLUE light 

Power on (new pairing mode)

Press power button for 3 seconds  Power ON / OFF

3.5 – 3.5mm female phone jack

Plug the audio cable to 3.5mm female phone jack input

System requirement

This device is Bluetooth V3.0 backward compatible. So if your Bluetooth device is V4.0 which have
to be V4.0 backward compatible that you can pair with this device.

2