Tech Lighting T-trak 700TTSCCADJ Series Installation Instructions Manual
Installation Instructions for
Adjustable Standoff With Conductive Connector
700TTSCCADJ_
920TTSADC
1.8
T ~ t r a k
TM
SPECIAL INSTALLATIONS
GENERAL PRODUCT INFORMATION:
C
This product is suitable for indoor dry locations only.
Use the adjustable standoffs every four feet of a SingleCircuit T~trak™ run.
Install the Standoff
1A
STANDOFF POST
CABLE POST
1
2
5/64" ALLEN WRENCH
#8-32 SET SCREW
CM
US
1C
5
ANCHOR
1
Remove the #8-32 set screw with the provided 5/64"
Allen wrench.
2
Remove the cable post from the standoff rod.
1B
CEILING
3
ANCHOR
4
3
Mark the standoff location points onto the ceiling.
4
Tap the anchor at the marked point into the ceiling up
to the threaded portion with a hammer.
5
Screw the anchor in the rest of the way with a Phillips
screwdriver.
1D
#8 SCREW
6
6
Fasten the standoff post to the anchor by inserting the
provided #8 screw through the standoff post and
screwing it to the anchor.
STANDOFF POST
1
1E
STANDOFF POST
CABLE POST
7
Push the cable post completely into the standoff post.
Align the cable post hole with the standoff post hole
8
8
7
5/64" ALLEN WRENCH
and replace the #8-32 set screw.
9
Tighten the #8-32 set screw with the 5/65" Allen
wrench.
#8-32 SET SCREW
9
1F
Mount the Single-Circle T~trak™ to
the Standoff With Conductive
Connector
NOTE: The two provided plastic inserts are not used
in this procedure.
2A
CONDUCTIVE
CONNECTOR
ONE SINGLE-CIRCUIT
T~TRAK SECTION
WHITE SIDE
WIRE GRIP
10
AIRCRAFT CABLE
TAB
11
WHITE SIDE
1
2
GRAY SIDE
BOTTOM #4-40 SCREW
NOTE: When the Single-Circuit T~trak is formed
into a shape, the ends become staggered. The
staggered ends have to be cut even with a
hacksaw. Refer to the Single-Circuit T~trak
instructions to trim the ends before proceeding
with these steps.
Push a Single-Circuit T~trak section all the way into the
1
THE OTHER
SINGLE-CIRCUIT
T~TRAK SECTION
4
conductive connector with its white side up.
2
Tighten the bottom #4-40 screw with a Phillips
screwdriver for a proper power connection.
GRAY SIDE
Push the tab down on the wire grip and feed the
10
aircraft cable through the wire grip post.
11
Pull the aircraft cable through the hole on the wire grip
post to adjust the standoff height.
12
Release the tab to lock the standoff in position.
3
Repeat steps 1 & 2 for the other Single-Circuit T~trak
section.
4
Cut the excess aircraft cable for a nice and neat look
with a sharp cutter after leveling all standoffs to the
desired height.
2
Loading...