Tech Lighting Mona Lisa Installation Instructions Manual
Installation Instructions for
920MONA
Mona Lisa Picture Light
MLP LONA ISA ICTURE IGHTS
GP I :ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
Minimum volume of the electrical box must be 6 cubic
inches (98 cubic centimeter).
For canopy installation see section 1.
For plug installation see section 2.
Installing the Fixture (Canopy Installation)
1A
34
ELECTRICAL
BOX
ANCHOR
1C
#6-32
SET SCREW
700DEMNLS__
6
7
1.0
FIXTURE ARMS
1/16 ALLEN
WRENCH
BRACKET
1
The picture light bracket should be mounted right above
the electrical box.
2
Hold the picture light canopy against the electrical box
and mark the bracket holes (1-1/4" apart) on the wall.
3
With a hammer tap the anchors at the marked points
into the wall up to the threaded portion.
4
Screw the anchors in the rest of the way with a Phillips
screwdriver.
1B
5
ANCHOR
5
Mount the picture light bracket on the anchors with the
two #8 screws.
#8 SCREW
6
Adjust the picture light height by loosening the two
#6-32 set screws on the front of the picture light
bracket with the 1/16 Allen wrench.
7
Slide the arms to desired height and tighten the two
#6-32 set screws with the 1/16 Allen wrench.
1
1D
1F
8
ELECTRICAL BOX
10
8
Connect the fixture cords to the fixture arms.
9
Feed the fixture cords through the canopy, then place
FIXTURE ARMS
FIXTURE CORD
CANOPY
9
the canopy against the electrical box and determine
wanted length of cord.
Once wanted length has been determined, trim the
10
cords leaving enough to make electrical connections.
1E
15 15
CANOPY
15
Mount the canopy to the electrical box with the two
long #8-32 screws.
1G
PICTURE
HANGING SLOT
PICTURE WIRE
16
LONG #8-32
SCREW
12
11
DRIVER
13
14
NOTE: Before making electrical connections, use the
provided universal round crossbar if the canopy
holes do not line up with the electrical box holes.
11
Connect the black driver wire to the hot power line wire
with a wire nut.
Connect the white driver wire to the neutral power line
12
wire with a wire nut.
13
Connect the fixture to a suitable ground in accordance
to local electrical codes.
PICTURE LIGHT
BRACKET
4" CANOPY
PICTURE
16
Hang the picture wire in the picture hanging slot on the
picture light bracket.
SKIP TO SECTION 3
Place the driver, all wires, and wire nut connections into
14
the electrical box.
2
Loading...