TECHLIGHTING Cosmo 18 Wall, Cosmo 12 Wall Installation Instructions Manual

Installation Instructions for
920OWCOSMO
Cosmo 12/18 Wall
OUTDOOR
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junction boxes.NEC
This product may be dimmed with a low-voltage electronic dimmer or a 0-10V dimmer depending on the wiring configuration.
Suitable for wet locations.
Install the Fixture
700OWCOS_
CAUTION RISK OF FIRE-
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
1.1
1A
FIXTURE SCREW
ALLEN WRENCH
1B
#8-32 SCREW
MOUNTING PLATE
3
1
1
#8-32 SCREW
3
ELECTRICAL BOX
1
With the provided Allen wrench, remove the two mounting plate screws.
Remove the mounting plate from the back of the
2
fixture.
Install the mounting plate onto the electrical box with
3
the two #8-32 screws provided.
1
1C
1D
6
4
5
7
4
Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes.
5
Connect the black fixture wire to the hot power line wire with a wire nut.
6
Connect the white fixture wire to the neutral power line wire with a wire nut.
7
Use the gray and purple dimming wires for 0-10v dimming application (if not in use, make sure to cap these wires off).
8
Properly place all wires and wire nut connections into the electrical box.
9
Mount the fixture by installing it back onto the mounting plate and reinstalling the fixture screws (reversal of figure 1A).
Warning: The purple and gray wires are only used for 0-10v dimming. For all other applications, do not connect the gray and purple wires.
Note for In-Line Fuse equipped fixtures: in the case that the fixture is not operating correctly, make sure to check the fuse.
10
For wet locations, caulk around the base with
waterproof construction sealant.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, 60077IL
847.410.4400
© 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.
www.techlighting.com
A Generation Brands Company
2
Loading...