Tech Lighting 700KESUN User Manual
Installation Instructions for
920KLSUNF
Kable Lite Sun
FUNC T ION A L AR T
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
Installing the Lamp
1A
1 1
1C
700KESUN_
1.6
BI-PIN LAMP
#8-32
SCREW
1
Remove all four #8-32 screws on Sun fixture so that it
splits into two parts.
1
1
1B
BI-PIN LAMP
2
3
SOCKET
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
NOTE: Use only your fingers and a soft cloth to
replace the lamp.
Use MAX 20 Watt, Bi-Pin Halogen Lamp.
Gently insert the new lamp pins into the socket holes.
3
4
Put the two Sun sections back together.
5
Align the screw holes, replace and tighten the four
#8-32 screws.
2
Remove the old lamp.
1
Installing the Sun Fixture
IMPORTANT SAFETY INSTRUCTIONS
2A
ARM
1 1
FOR VERTICAL
KABLE LITE CABLES
NOTE: The Kable Lite cable separation must be
between 7.5" to 8".
Sun can be connected to horizontal or vertical Kable Lite
1
cables by rotating the arms 90°.
FOR HORIZONTAL
KABLE LITE CABLES
2B
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to person:
– Use this fixture indoors only.
– Do not look directly at the lighted lamp.
– Do not remain in light if skin feels warm.
– Risk of fire: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
– Never cover the halogen lamp with anything other than a
Tech Lighting lamp shield and never place flammable
material close to your fixture.
– Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
– Do not touch the fixture shades or lamp shield while the
fixture is on. These surfaces may be HOT.
Halogen Lamp General Information
– A new halogen lamp may smoke slightly when it is used for
the first time. This is perfectly normal; the protective
coating is simply being vaporized.
3
ARM
KABLE LITE CABLES
2
Loosen the thumb screws.
3
Place one arm slot on each Kable Lite cable and tighten
the thumb screws.
SAVE THESE INSTRUCTIONS!
THUMB
SCREW
Two Tips For Prolonging Halogen
Lamp Life
– First avoid touching the lamp with bare hands during
2
installation. Any contaminant, even the oil from your
hands can deteriorate the lamp. Rubbing alcohol can be
used to remove any contaminant.
– Second, do not run the lamps at full power when you do
not need to. However, if dimming the fixture for an
extended period of time, occasionally bring the light up to
full brightness for a few minutes to complete the halogen
cycle.
7400 Linder Ave, Skokie, IL 60077
847.410.4400
© 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
www.techlighting.com
A Generation Brands Company
2
Loading...