Tech Lighting 700FJTRPN User Manual
Installation Instructions for
920FJTRPD
Torpedo Pendant
PENDA NTS- LOW VO L TAG E
GENERAL PRODUCT INFORMATION:
This product is ETL listed and suitable only for indoor dry
locations and approved for use at any height above the
finished floor.
This product is patented (U.S. PAT. 6,183,297).
Adjust The Fixture Height
700FJTRPN_
1.8
1A
1/16 ALLEN WRENCH
#6-32 SET SCREW
1
Back out (do not remove) the #6-32 set screw on tip of
the connector with the provided 1/16 Allen wrench.
1B
1/16 ALLEN WRENCH
#6-32 OVAL HEAD
SET SCREW
2
1C
1
4
Cut the coaxial cable to the desired length.
5
Gently twist the end of the coaxial cable between thumb
and forefinger.
5
1D
6
3
Back out (do not remove) the #6-32 oval head set screw
2
on the conical connector with the provided 1/16 Allen
wrench.
3
Pull the coaxial cable out.
CONICAL CONNECTOR
6
Feed and push the coaxial cable into the conical
connector. The coaxial cable will come to a stop point
after being inserted 3/4" into the conical connector.
1
OUTER WRAPPED
WIRE STOPS HERE
1E
WRINKLE ON OUTER
WRAPPED WIRE
1H
7
INNER WIRE STOPS HERE
Keep pushing the coaxial cable into the connector while
7
rotating the connector to ease feeding the inner wire
into the tip of the connector. The outer wrapped wire
will start wrinkling while being inserted another 1/2" into
the connector.
1F
1/16 ALLEN WRENCH
INNER WIRE
9
11
11
Pull the coaxial cable toward the fixture to smooth the
wrinkles.
8
SIGHT HOLE
Look into the sight hole on the top of the connector to
8
make sure that the inner wire is contacting the end of
the connector.
9
Hold the coaxial cable in place and tighten the #6-32 set
screw on tip of the connector with the provided 1/16
Allen wrench. Make sure that this set screw
connection is tight.
1G
10
10
Tighten the #6-32 oval head set screw on the conical
connector firmly.
2
Loading...