TECHLIGHTING 700DJTELC Installation Instructions Manual

Installation Instructions for

920DJTELE

DJ-Telescope

DISPLAY JACK

GENERAL PRODUCT INFORMATION:

This product is suitable for indoor dry locations only.

Wild Thing, Sun Louver, Flight Paper, MR16 Snout, Round
Glass Shield, Lil Egypt, Lil Wok, Barndoors, Snap Barndoors,
Backlight Shield, Louver Lend Holder, Snap Louver Holder,
Eggcrate Louver, and Glass Lens are the compatible
accessories and optical controls.

Installing the Lamp

1E

700DJTELC

1.6

1A

LAMP PIN

CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.

NOTE: Use only your fingers and a soft cloth to

replace the lamp.

1

SOCKET PIN

1B

SLOT IN THE MIDDLE
OF THE SOCKET

LAMP HOLDER
SPRING

2

Hook one end of the lamp holder spring (provided with
the package) onto front of the lamp. Wrap the spring
over the slot in the middle of the socket and hook the
other end onto front of the lamp.

2

HOOK IT HERE

HOOK IT HERE

MR16 LAMP

2

Use MAX 75 Watt, MR16 Front Cover Halogen
Lamp.

1

Push the MR16 lamp pins all the way into the socket
pins.

1

Installing the Separator

IMPORTANT SAFETY INSTRUCTIONS

2A

FIXTURE WIRES

SEPARATOR

1

#6-32 SET SCREW

1/16 ALLEN WRENCH

NOTE: To avoid an electrical short between the

fixture wires, a separator must be snapped between
the fixture wires so that the wires are equal distance
from each other.

1

Secure the separator between the fixture wires by
tightening the #6-32 set screws with the 1/16 Allen
wrench.

To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to person:

– Use this fixture indoors only.

– Do not look directly at the lighted lamp.

– Do not remain in light if skin feels warm.

– Risk of fire: Use only the type of lamp and maximum
wattage indicated in this instruction manual.

– Never cover the halogen lamp with anything other than a
Tech Lighting lamp shield and never place flammable
material close to your fixture.

– Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.

– Do not touch the fixture shades or lamp while the fixture
is on. These surfaces may be HOT.

– The MR16 lamp must have a protective front cover glass.

Halogen Lamp General Information

– A new halogen lamp may smoke slightly when it is used
for the first time. This is perfectly normal; the protective
coating is simply being vaporized.

SAVE THESE INSTRUCTIONS!

Two Tips For Prolonging Halogen
Lamp Life

– First avoid touching the lamp with bare hands during
installation. Any contaminant, even the oil from your
hands can deteriorate the lamp. Rubbing alcohol can be
used to remove any contaminant.

– Second, do not run the lamps at full power when you do
not need to. However, if dimming the fixture for an
extended period of time, occasionally bring the light up to
full brightness for a few minutes to complete the halogen
cycle.

7400 Linder Ave, Skokie, IL 60077

847.410.4400

© 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.

www.techlighting.com

A Generation Brands Company

2