Tech Lighting 700BCSIBS-CF Series Installation Instructions Manual

Installation Instructions for

920BCSIBSCF

Siber Mirror Surface (Fluorescent)

BATH COLLECTION

GENERAL PRODUCT INFORMATION:

This product is suitable for damp locations.

Bring power supply lines to the mirror in accordance with
local electrical codes.

This instruction shows a typical installation.

700BCSIBS_-CF_

CAUTION—RISK OF FIRE

This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and DISCONNECT POWER TO THE
ELECTRICAL BOX.

1.0

Install the Hardware

1A

BACKPLATE

2 2

2

2

1 1

1

Locate the studs on the wall where the mirror is going
to be mounted (Max 28-1/4" separation).

2

SCREW

WASHER

STUD

1B

4 4

3

4

3

Bring the power line to one of the four circular holes on
the backplate.

4

POWER LINE

Use minimum of four slots to mount the back plate to

2

the studs with four screws and washers provided. Do
not drive the screws all the way in at this time.

While holding the back plate level and in the desired

4

position, tighten the four screws to secure it.

1

Prepare the Fixture for Installation

Install the Fixture

2A

3

KNOCKOUT

2

Remove the six screws on side of the center housing in

1

the center of the pan.

2

Remove the center housing lid.

3

Remove one knockout and install the provided conduit
connector.

LID

3A

THREADED

ROD

2

1

POWER

LINE

1

Feed the power line wire through the conduit connector

PAN HOLE

2

CONDUIT

CONNECTOR

into the pan.

2

Place the four pan holes onto the four back plate
threaded rods.

3B

3

3

NUT

3

Mount the pan to the backplate with the provided

3

3

washers, lock washers and nuts.

2