Page 1
OPERATION
The TECHKO model S201 Solar Yard Alarm and Garden
Light is equipped with a remote control unit to operate
the unit’s Alarm on, Chime on, and turning off functions.
SOLAR YARD ALARM
1.To arm the Alarm : press the button "Alarm", and a short
beep will sound to indicate the unit is in operation.
To arm the Chime: press the button "Chime", and a
chime will sound to indicate the unit is in operation.
You will have approximately 15-20 seconds to exit the
area under Alarm or Chime mode.
2. To disarm the unit: press "Off" and two short beeps
will sound indicating the unit is off. You would have
approximately 5-10 seconds to turn the unit Off while
the red LED light flashes. It will flash 10 times before
the alarm will sound.
3. If the detected area is entered, with in approximately 5
seconds, the unit will automatically sound a 6 tone
alarm lasting approximately 60 seconds with a bright
red LED light flashing. Afterwards, the unit will
automatically reset and resume protection.
4. Entry delay
There will be a 5-10 second delay to allow user to turn
off the alarm.
Exit delay
When turning on the alarm, there will be a 15-20 second
delay to allow user's exit.
SOLAR GARDEN LIGHT
The Solar Garden Light will turn on and off
automatically when it becomes dark or light. It will
light for 6-8 hours subject to the intensity of daily
sunshine.
PATENT PENDING NOTICE
CAUTION
THE SOLAR YARD ALARM IS EXTREMELY LOUD. FOR YOUR
SAFETY, NEVER PLACE THE UNIT CLOSE TO YOUR EARS.
TO TEST THE ALARM, DIRECT THE UNIT AWAY FROM YOU
AT ARM’S LENGTH AND THEN ACTIVATE.
Customer Service :
1-888-8TECHKO (1-888-883-2456)
Website: www.techkomaid.com
Mfg. By
9767 Research Drive
Irvine, CA 92618-4626
MADE IN CHINA
USA Patent Pending No. 12/795,194
THIS PRODUCT IS PROTECTED UNDER FEDERAL PATENT. TRADEMARK
AND COPYRIGHT LAWS AND LAWS PREVENTING UNFAIR COMPETITION.
NO DUPLICATION OR SIMULATION OF THIS PRODUCT IS PERMITTED
EXCEPT BY WRITTEN AUTHORIZATION OF TECHKO, INC.
TECHKO AND THE CONFIGURATION OF THIS
PRODUCT ARE TRADEMARKS OF TECHKO, INC.
COPYRIGHT 1992 TECHKO, INC.
ALL RIGHTS RESERVED
MADE IN CHINA
Solar Yard Alarm &
Garden Light
MODEL S201
A
L
AR
M
C
HI
M
E
O
F
F
LOW BATTERY INDICATOR
The LED indicator light is located on the front of
the unit. This will light up when the solar battery
becomes low.
OPERATION MANUAL
Page 2
INTRODUCTION
Protect your yard and other important surrounding
areas with the TECHKO Solar Yard Alarm & Garden
light! Simply piece together and place firmly into the
ground next to the desired area of protection. Let it
charge, turn it on with the remote and you’re done !
Recharges daily by the sun. No batteries needed !
This unit can be placed in your yard, garden, pool area,
or other areas in need of protection, while adding a
decorative touch.
INSTALLATION
To install the unit:
(Fig.1)
Component Illustration
Solar Panel for Light
Flashing Alarm LED light
PIR Motion Sensor
Off
ALARM
CHIME
OFF
ALARM
Alarm
LED Light
CHIME
Garden Light
Solar Panel for Alarm
FEATURES
* Solar powered
* High power output alarm
* 2 sensors to correctly detect a real motion threat
* Remote control for arming and disarming
* Red flashing LED light indicates intrusion
* Easy to install
* Low battery LED indicator
* Alarm/Chime Option
IMPORTANT SAFETY TIPS
1. Read all installation and operating instructions.
2. Avoid dropping or rough handling.
3. Be careful not to damage the plastic lens.
4. The solar yard alarm siren is very loud, never put the
unit close to your ear.
5. This unit should be directed away from extreme heat
sources.
6. If the unit goes off at random, it is possibly located
too close to a heat source, or located too close to
normal wanted activity. Changing the location or
direction of the unit may fix this problem.
7. This unit can provide valuable protection for your home
or property if used properly. However, this unit cannot
guarantee complete protection against pool area entry
or burglary. Therefore, TECHKO will not be held
responsible for any loss or damages which could occur.
8. Keep this operation manual in a convenient place
for future reference.
Before using, remove the plastic pull tab by
pulling it down and out of its position. This
allows the internal batteries to now connect
to solar power. (Fig.2)
Remove before use
Battery cover
Solar panel
Fig. 2
Open solar panel and unscrew the battery
cover (4 screws), and insert battery plug into
connector. Replace cover and screws.
Fig. 3
For best coverage, this unit should be placed in a
corner location to cover 7 meters (23 feet) outward.
The area of coverage provided by the unit is
approximately 90 degrees vertically and 110 degrees
0
horizontally with a range of approximately 23 feet
from the unit. (Fig. 4)
When choosing the desired area of protection, make
sure the area is wide open and that it is not placed
behind bushes, hanging branches or similar moving
shrub. This may cause confusion to the unit and set
off false alarms.
Approximately
0
90
Approximately 23 ft
Approximately
110
0
Fig. 4
Loading...