Tech Art Enterprise XB862 User Manual

RF 2.4GHz Wireless Game pad

Device (Controller) Use Instructions

1. Power ON the Device (Controller).

2. The Device will be in searching the Host for building up the connection in 3 seconds:
X If after 3 seconds, there is no connection (say, no Host, or failure in connectio n), the Device will enter normal

transmitting mode.

X If the connection is built, then the Device will enter normal connection mode.

3. No matter when the Device is in normal transmission mode or in normal connection mode, you can switch or set to
different modes by pressing the following button combinations:

To set different modes:

X BACK + A Will enter connection mode
X BACK + B Will enter RF transmitting mode
X BACK + LEFT Will enter Sleep mode

To set different channel

X BACK + UP To fix the RF channel to Channel 79
X BACK + RIGHT To fix the RF channel to Channel 39
X BACK + DOWN To fix the RF channel to Channel 0

Note: There is totally 80 channel is designed. That is, Channel 0~79.

For Example:
Example 1:

When the Device and the Host are in connection, you want to enter Channel 79 and RF transmitting mode, you can fulfill by
following steps:

Step 1: BACK + UP

Step 2: BACK +B

Example 2:

The Device is not in connection, but you want to enter Channel 0, and Connection mode, then you can fulfill by the
following steps:

Step 1: BACK + DOWN

Step 2: BACK + A

Typical Product Characteristics:

Items Description

Number of Channels 80
Frequency Band 2402 MHz ~ 2481 MHz
Antenna Type PCB Antenna
Test Power Source DC 4.5V From battery

Temperature Range(Operating)

Basic Function:

- Fully compatible with XBOX Platform

- Low power Indicator

- Power on/off selection

- Rubber grips

- 7 Meter(20ft) 2.4G RF wireless transmitting distance

0 ~ 50 ℃

FCC NOTICE

1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that

may cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.