Tech4home Lda CSR001 User Manual

Take O Guide

CASTER

remote control

1 Caster Remote Control

CSR001; T4HXXXXXXXXXX Caster product family

Status LED

Digit Keys

Power

Voice control

2 Turn On Caster 3 Caster Control Your STB

Caster remote control arrives with a 2 AAA batteries blister inside a polybag. To turn on your Caster remote control, please follow the instructions below.

1. Turn ON your

Set T

op Box.

TV and your

Remove your Caster

remote control and the

Remove the battery lid. 4. Place the batteries on the

batteries from the plastic bag.

Caster remote control as indicated in the image above and close it with the battery lid.

After place the batteries,

wait a few seconds and the Caster is ready to operate.

Caster remote control is able to control your STB by IR or BLE connection. To perform this test, execute the following steps..

Press two keys simultaneously

If the RCU is connected by IR, the LED will turn green.

3. If the RCU is connected by BLE, the LED will turn blue.

If you change the function or have trouble operating the remote, open the battery cover

Note:

and press the Reset button for more than three seconds to restore the command to the factory conditions.

FCC Compliance Statements

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televison reception, which can be determinated by turning the equipment off an on, the user is encouraged to try to correct the interference by one or more of the following measures:

. Reorient or relocate the receiving antenna.

. Increase the separation between the equipment and receiver.

. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation expuser limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.