Team Electronic UHF-DualTalk Operation Manual
Operation Manual
electronic
UHF-DualTalk
Public Mobile Radio +
Low Power Device
1
2
3
4
5
4
6
7
8
9
10
electronic
2
UHF-DualTalk
PMR + LPD Radio
1.) Antenna
2.) Jack SP./MIC
3.) LCD Screen
4.) Up & Down Key
5.) Confirmation & On/Off Key
6.) Speaker
7.) Mic: Microphone
8.) Volume Key
9.) PTT Key
10.) Call Tone Key
3
Page
Controls & Connectors ............................. 2 - 3
LC-Display ..................................................... 5
Set Up……………………………………………. 6
1) Inserting the batteries .................................. 6
2) Switching On/Off: ........................................ 6
3) LCD illumination .......................................... 7
4) Key lock function .................................……. 7
5) Automatic abortion of functions ................... 7
6) Up ▲ and Down
▼ keys .............................. 8
7) Socket for external ear- & microphone ....... 8
8) Battery indication........................................... 8
9) Power save function...................................... 9
10) Receipt tones...............................................9
Operation……………………………………….. 10
1) Band and channel selection........................ 10
2) Channel selection within the actual band… 11
3) Activation of the CTCSS function &
selection of the CTCSS tone ...................... 11
4) Volume adjustment .................................... 12
5) Squelch adjustment ............................…… 13
6) Setting of the VOX function ....................... 13
7) Selection of the call melody ...................... 15
Specifictions are subject to change without any
prior notice or obligation.
Contens
English
4
Page
8) Monitor function ..............................…….15
9) Activating of the channel scan function..... 16
10) Transmitting…………………………….......17
Additional Information
Safety…………………………………………. 18
Service………………………………………... 19
Conformity……………………………………. 19
Accessories………………………………22 - 23
Frequency tables………………………..20 - 21
English
5
A Appears if normal PMR status is activated or if Vox is switched on.
D Indicates the actual condition of the batteries.
F Indicates the selected PMR channel 1 - 8.
C Appears if key lock function is activated
B Indicates the selected frequency band, i.e. PMR or LPD.
G Indicates the selected CTCSS Code 1 - 38.
E Indicates receiving signals or for transmitting mode.
R
T
LC-Display
A
B
C
D
EF
G
Main Screen
o
I
Setting up the TEAM UHF-DualTalk
1) Inserting the batteries
Turn the unit in that way that the rear panel lies in front of you. Rotate the belt clip a
quarter turn counter-clockwise, so that the battery compartment lid is accessible now.
The locking of the battery compartment lid is located at the bottom side of the unit.
Push the locking aside and turn it down. Then you can take the lid off.
Now insert 4 alkaline or rechargeable AAA ( = Micro ) cells into the battery compartment according to the polarity signs inside. If you use rechargeable cells we recommend the NiMH type.
To close the battery compartment put the lid onto the compartment in that way that the
two guide bolts at the top of the lid grip into the two corresponding guide holes at the
top of the battery compartment. Then secure the lid by pushing the locking on it until
it snaps in. Finally rotate the belt clip back into its original position
2) Switching On/Off
Depress the confirmation CONFIRM and On/Off key ( 5 ) for about 1 or 2 seconds
to switch the transceiver on. A short receipt tone sounds from the loudspeaker ( 6 )
and the display illumination lights up in green. For a short period the graphic display
( 3 ) shows all points. Now the unit is either in PMR reception mode or in LPD reception mode. The display will show the main screen which indicates also the actual
band. To switch the unit off depress the confirmation and On/Off key ( 5 ) again
for about 1 or 2 seconds. The loudspeaker gives a short tone and all symbols disappear from the display. The last settings remain memorised, even if the batteries are
removed.
English
6
English
7
Note: The On/Off operation of the confirmation and On/Off key ( 5 ) is disabled after
the last confirmation. This factory setting has been made to avoid an unwanted
On/Off switching of the unit. The disabling of the On/Off function will be cancelled
after the key ( 5 ) is released once for a short time.
3) LCD illumination
The LC display illumination is switched on at every pressure on any key, and it will be
automatically shut off after 10 seconds.
4) Key lock function
The key lock function is activated from the main screen. The unit can be in PMR
mode or in LPD mode. Depress and hold the confirmation key ( 5 ). While you hold
this key, press also the Up key ( 4 ). Then two short confirmation tones sound
from the speaker ( 6 ), and the key symbol ( position C ) appears in the display.
Now all keys except the PTT key ( 9 ) are ignored. The speaker gives two short tones
at every pressure on any locked key, except the confirmation key ( 5 ).
To stop the key lock function depress and hold the confirmation key ( 5 ). While you
hold this key, press also the Up key s ( 4 ). Then one single short confirmation tone
sounds from the speaker, and the key symbol disappears in the display. Now all keys
are unlocked again.
5) Automatic abortion of functions
If you select a function in the main screen, you have to insert all necessary entries within 5 seconds, otherwise the function will be aborted and not executed. Instead the
▼
display returns to the main screen.
6) Up and Down keys
If you depress briefly the keys Up and Down ( 4 ), the corresponding values
( volume, channel ) are changed for one step up or down. If you hold these keys for
1 or 2 seconds, the values change quickly into the corresponding direction. Some
values run in a ring like system, others remain constantly after they have reached the
highest or lowest value. In this case you will hear from the speaker a triple confirmation tone.
7) Socket for external earphone-microphone
The socket ( 2 ) ( ø 2.5 mm ) on the top side of the unit can be used to connect an
external earphone-microphone, e.g. ORM-MS. While the socket is used the internal
speaker ( 6 ) and the internal microphone Mic ( 7 ) are switched off.
8) Battery indication
In case of completely charged batteries the battery symbol ( position D ) is filledin. At 4.9 V supply voltage one third of the filling disappears, at 4.6 V one other third,
and at 4.1 V there is only the frame remaining. Now it is time to change or charge the
batteries, otherwise errors of functions and displayed information may occur. The current consumption in transmit mode amounts to 270 mA ( PMR mode ), 110 mA ( LPD
mode ), in reception mode with closed squelch 40 mAand in power save mode 15 mA.
English
8
▼
▼
▼
▼
Loading...