TDK-Lambda Genesys Series, G/P-4U-150-600V, G/P-4U-60-100V, G/P-4U-10-40V, G/P-6U-60-100V Instruction Manual

Series

Programmable DC Power Supplies

G1.7 ÷ 5kW in 1U 60-100V / 17-85A

The manual covers kit options:

G/P-6U-60-100V

PARALLEL KIT INSTRUCTION MANUAL

IA902-04-01A

*Z0022573*

Z0022573

2

1.1

General

Parallel kit is supplied separately from the power supply packing according to order.

The usage of parallel kit is according to customer's needs.

1.2

Advanced Parallel

For parallel connection, refer to advanced parallel chapter in the series User Manual.

1.3

Product Safety Instructions

Safety approvals are valid for single unit only. These are not valid for parallel kit assembly.

When using a paralleling kit with a protective bracket, it must be correctly assembled, as described further in this
document.

1.4

Assembly Instructions

The supplied kit is used for standard and blank panel options. Follow the instructions carefully according to power
supply model.

1.4.1 G/P-6U-60-100V - Assembly Instructions for six 60V÷100V units in

Parallel

1.4.1.1 Components List

Image Component Quantity

10-32 x 5/16 Pan Head Screw, Stainless Steel 24

Helical Spring-Lock Washer, No. 10, Stainless Steel 24

Plain Washer, No. 10, Stainless Steel 24

Connection Plate 6U 2

Output Bus Bar Plate 2

Paralleling Cable 5

3

Image Component Quantity

M8 x 25 Hexagon Bolt, Stainless Steel 12

Plain Washer, M8, Stainless Steel 24

Helical Spring-Lock Washer, M8, Stainless Steel 12

Hexagon Nut, M8, Stainless Steel 12

1.4.1.2 Installation Steps

1. Attach connection plates, one on each side of the power supplies, using 24 pan head screws, 24 helical

spring-lock washers and 24 plain washers as illustrated in Figure 1.

Figure 1: Six 60V÷100V Units Connection Plates 6U Assembly

Connection Plate 6U

Plain Washer, No. 10, Stainless Steel

Helical Spring-Lock Washer, No. 10, Stainless Steel

10-32 x 5/16 Pan Head Screw, Stainless Steel

Tightening torque: 25.4-31.7 Lbf-inch (2.87-3.58Nm).

4

2. Attach output bus bars plates, one on each sextet terminals, using 12 hexagon bolts, 24 plain washers, 12

helical spring-lock washers and 12 hexagon nuts as illustrated in Figure 2.

Figure 2: Six 60V÷100V Units Output Bus Bars Plates Assembly

3. Connect five paralleling cables from top unit M connector to bottom unit S connector as illustrated in

Figure 3.

Figure 3: Six 60V÷100V Units Paralleling Cable Connection

Output Bus Bar Plate

Paralleling Cable

M8 x 25 Hexagon Bolt, Stainless Steel

Tightening torque: 106-132 Lbf-inch (12-14.9 Nm)

Plain Washer, M8, Stainless Steel

Helical Spring-Lock Washer, M8, Stainless Steel

Hexagon Nut, M8, Stainless Steel