TDK Velocd Quick Manual

HIGH SPEED USB 2.0 EXTERNAL
CD-REWRITABLE DRIVE FOR PC

V1

FCC Notice

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy, and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee interference will not occur in a particular installation. If this
equipment causes harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

> Reorient or relocate the receiving antenna.
> Increase the separation between the equipment and receiver.
> Connect the equipment to an outlet on a circuit different from that to which

the receiver is connected.

> Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications should be approved by the party responsible for compliance
with FCC Rules; otherwise, the user loses authority to operate the equipment.

The laser beam emitted from the optical pickup is invisible.
Accordingly:

> Do not open the optical pickup housing.
>

Obtain service only from TDK-authorized personnel.

LASER INFORMATION

This product has been designed and manufactured according to IEC 825-1 on the Safety of
Laser products. This product comes under “Class 1 Laser Products.” A Laser Caution
Marking is attached on the top of the internal drive model: “Caution: Invisible laser radia­tion when open. Avoid direct exposure to beam.”

CAUTION: Improper use of controls
adjustments, or performing procedures
other than those specified herein may
result in hazardous radiation exposure.

CAUTION: Your CD-R/W drive
contains sensitive, high-precision optics.
Dropping and/or shaking the CD-R/W
drive could damage these sensitive
components. Please be careful when
handling your CD-R/W drive.

CAUTION: Any changes not
approved by the manufacturer could
void the user’s warranty and authority
to operate the equipment.

48X HIGH-SPEED USB 2.0 EXTERNAL CD-RW DRIVE

SUPPLIED WITH:

veloCD Drive

USB 2.0 Cable (A-B)
PC Software
AC/DC Adapter
Drive Stand
Emergency Ejector Pin
Manual
Quickstart Guide

MINIMUM SYSTEM REQUIREMENTS:

Windows:

Pentium III 333 MHz or higher
Windows 98SE/ME/2000/XP
64 MB RAM

• NOTES: When connected to the computer via
a standard USB 1.1 port, the drive's maximum
write speed is 4X due to bandwidth limitations.
Connect to the computer via USB 2.0 for
48X write speed performance.

1.Insert the program installation CD into your computer’s original disc
drive to install the software programs and Hi-Speed USB driver.

2.Install the TDK CD Blender Recording Software Suite by clicking
on the desired programs. Follow the on-screen prompts to
finish installation.

3.Locate the USB 2.0 port on your PC.

4.Connect the flat end of the USB cable to the PC’s USB 2.O port.

PLUG AND

PLAY

EASY TO SET-UP AND USE

4

5

6