TREK 360 Battery Replacement Instructions
Caution: Disconnect the TREK 360 power and place the power switch on the rear
of the unit in the OFF position before beginning the replacement.
1. Place the unit on its left side. Using a
T-5 Torx driver, remove the four screws
holding the battery cover plate.
2. Place the unit upright. With a
jeweler’s screwdriver or a tweezers,
carefully pry out the battery cover
plate.
3. The battery compartment.
4. Using a screw driver, lift on the
lower corner of the battery
assembly and rotate upwards. The
battery will not lift straight up.
5. Lift the battery out.
6. Using fingers or a needle nosed
pliers, unplug the connector.
7. Remove the old battery and insert the replacement.
8. Plug in the connector, press the cable in place and replace the battery cover.
9. Reinstall the four retaining screws.
Proper disposal of the old battery is essential from an environmental and safety
point of view. Please follow local regulations for proper disposal. Putting any
battery directly in the trash will harm the environment.
Do not incinerate.
Loading...