TCT Mobile 509 User Manual

Page 1
EC01 (E-Card)
Quick Start Guide
CJB3430ALAAA
Page 2
Your E-Card ������������������
1
1�1 Keys and connectors
Power key
Idle screen
Left key
Left key
• Press to turn to the last page.
• Press to mute the ringtone when there’s an incoming call.
Right key
• Press to turn to the next page.
• Press to reject the ringtone when there’s an incoming call.
Center key
• Press to adjust font size.
1
Right key
Page 3
Power key
• Press: Switch between idle screen and previous
application screen.
• Press and hold to power on/off.
...X...
Disconnected indicator
• It will be shown to remind your E-card is disconnected.
1�2 Installation
Download and install two APKs on your phone.
iReader is a APK with reading program.
ONETOUCH E-CARD is a APK which connects and transfer data between phone and E-Card, it need to match with iReader.
1�3 Getting started
1�3�1 Power on your phone
Hold down the Powe r key until the phone powers on. It will take a few seconds before the screen lights up.
1�3�2 Power off your phone
Hold down the Powe r key.
1�3�3 Charging the battery
Connect the battery charger to your phone and mains socket respectively.
The charging status bar will not appear if your battery charge is very low. To reduce power consumption and energy waste, once the battery is fully charged, disconnect your charger from the plug.
2
Page 4
iReader ����������������������
2
Launch iReader application on your phone, open a book on bookshelf, and touch Transfer button. If you E-card is connected with your phone successful, this book will be projected on E-card. Then you can start reading on E-card.
Back to bookshelf
Transfer to E-card
Add a bookmark
3
Page 5
ONETOUCH E-card
3
3�1 Notification
In reading mode or idle, if there’s incoming call, new mail, new message and alarm, you can see notification on E-card.
Open ONETOUCH E-card on phone and select activation mode for these notifications.
• When reading
• Always
• Never
If you activate notification on your E-card, you can do further operation.
Incoming call New message
4
Page 6
New mail Alarm
3�2 Weather
Open ONETOUCH E-card, select Weather update to change interval.
Pairing ��������������������������
4
You have two ways to connect you E-card with mobile phone.
• Bluetooth
• NFC
When you launch iReader on phone and touch Transfer button, it will indicate you and switch to relevant menu and make connection.
5
Page 7
Troubleshooting�������������������
Pleas e refer to t he inst ruct ions bel ow befor e contac ting ou r after-sales service:
1. Pairing Failures
Since signal interference may occur with Bluetooth connections, the pai ring tim es may di ffer fr om case t o case. I f pairi ng atte mpts kee p faili ng, ple ase try t he foll owing sug gest ions be fore re-connecting:
A. Reboot Bluetooth;
B. Rebo ot your ce llphon e;
C. Che ck whet her it is c harged ;
D. Log out o f your E-C ard and lo g in agai n.
2. Batt ery no t Charge d
Pleas e check w hethe r the Core box inse rted c orrect ly into t he charg er (refer t o the pic ture in sec tion 1.2) .
Afte r the bat tery i s tota lly cons umed, it w ill ent er a pre- charg ing perio d. Aft er 3 to 5 minu tes' ch arging , it will e nter a nor mal charg ing peri od (the ch arging l ight wil l indic ate norm ally).
3. Vibra tion and L ED ligh ts not wor king
Charg e and conf irm th at the bat ter y works, t hen st art pa iring. I f the pai ring fa ils, ref er to “P airing F ailure s”. If the pai ring suc ceeds , check the indicator lights and the vibrator by knocking.
4. Unexp ecte d vibrat ion or bl ink: th is may be c aused by misoperation.
5. Fact ory re set
If the in struc tions a bove do no t solve your i ssue, t ry rese ttin g your Core box as a la st resor t. Fi t the Core box into t he char ger, then in sert a p aper cli p or simil ar alte rnati ve into th e Reset ho le. Push sl ightly u ntil a cl ick is hea rd, the n all 5 LED i ndicat or light s will bli nk toge ther, follo wed by the 1st l ight bli nking.
6
Page 8
Safety and use ����������������������
It is recommended to read all safety content before using E-Card. The E-Card manufacturer is not liable for results caused by improper usage or failure to follow this manual.
Please carefully read through and follow the instructions below:
• Pay attention to any warning.
• Don’t attempt to open the Corebox. Under inappropriate
operation, the product and the battery can be hazardous to the human body and the environment.
• Don't disturb the normal working of E-Card.
• Don’t clean E-Card with corrosive cleaning products.
• Don’t place E-Card in dishwashers, washing machines or dryers.
• Don’t expose E-Card to extreme temperatures.
• Don’t expose E-Card to prolonged direct sunlight.
• Don’t place E-Card close to fire.
• Don’t throw E-Card into fire. This may cause the battery to
explode.
• Don’t attempt to disassemble E-Card. The components cannot
be repaired.
• Don’t allow children to play with E-Card. Small components may
present a choking hazard to children.
7
Page 9
General information �����������
• Internet address: http://www.alcatelonetouch.com
• Address: Room 1910-12A, Tower 3, China HK City, 33 Canton
Road, Tsimshatsui, Kowloon, Hong Kong
This equipment is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The entire copy of the Declaration of Conformity for your telephone can be obtained through our website: www.alcatelonetouch.com.
• LICENCES
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by TCT Mobile Limited and its affiliates is under license. Other trademarks and trade names are those of their respect-ive owners.
ALCATEL ONETOUCH EC01Bluetooth Declaration ID B0XXXXX
XXX
(NFC)
8
Page 10
Note: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference
(2) this device must accept any interference received, including interference that may cause undesired operation.
9
Page 11
• Regulatory information
The following approvals and notices apply in specific regions as noted.
10
Page 12
ALCATEL is a trademark of ALCATEL-Lucent
and is used under license by
TCT Mobile Limited.
© Copyright 2014 TCT Mobile Limited
All rights reserved
TCT Mobile Limited reserves
the right to alter material
or technical specification
without prior notice.
11
Loading...