This data sheet contains information that is confidential to TONLY ELECTRONICS
HOLDINGS LIMITED. Unauthorized use or disclosure of the information contained herein is
prohibited. You may be held responsible for any loss or damages suffered by TONLY
ELECTRONICS HOLDINGS LIMITED . for your unauthorized disclosure hereof, in whole or in
part.
Information herein is subject to change without noticed.TONLY ELECTRONICS HOLDINGS
LIMITEDdoes not assume any responsibility for any use of, or reliance on, the information
contained herein
THIS DATA SHEET AND ALL INFORMATION CONTAINED HEREIN IS PROVIDED “AS IS”
WITHOUT WARRANTY OF ANY KIND, WHETHER EXPRESS, IMPLIED, STATUTORY, OR
OTHERWISE. TONLY ELECTRONICS HOLDINGS LIMITED.SPECIFICALLY
DISCLAIMS ALL IMPLIED WARRANTIES OF MERCHANTABILITY, NON-INFRINGEMENT,
AND FITNESS FOR A PARTICULAR PURPOSE. NEITHER DOESTONLY ELECTRONICSHOLDINGS LIMITED. PROVIDE ANY WARRANTY WHATSOEVER WITH RESPECT TO
THE SOFTWARE OF ANY THIRD PARTY WHICH MAY BE USED BY, INCORPORATED IN,
OR SUPPLIED WITH THIS DATA SHEET, AND USER AGREES TO LOOK ONLY TO SUCH
THIRD PARTY FOR ANY WARRANTY CLAIM RELATING THERETO. TONLY
ELECTRONICS HOLDINGS LIMITED. SHALL ALSO NOT BE RESPONSIBLE FOR ANY
TONLY ELECTRONICS HOLDINGS LIMITED DELIBERABLES MADE TO USER’S
SPECIFICATION OR TO CONFORM TO A PARTICULAR STANDARD OR OPEN FORUM.
Tonly is a trademark of TONLY ELECTRONICS HOLDINGS LIMITED. other names mentioned
in this document are trademarks/registered trademark of their respective owners.
This data shall be executed in two languages including one Chinese and one English. Any conflict
exist between the two languages, theChinese will prevail in any time.
- 2 -
Page 3
EXM1020D Module Datashee
TCL 通力电子(惠州)有限公司
惠州 TCL 音视频电子有限公司
深圳市通力科技开发有限公司
Revision
版本
版本变更说明
Date
日期
Document Revision History
Author
作者
版本:V1.0
生效日期:2018-05-31
Description
描述
V1.02018-05-31Tan LunqiangFirst Release
- 3 -
Page 4
EXM1020D Module Datashee
1. 系统概览 System overview
1.1 通用说明 General Descriptions
1.2 性能特点 Features
1.3 系统框图 Block Diagram
2. 产品描述 Production Description
2.1 引脚与功能说明 Pin Layout &Pin Description
2.2 外观与尺寸 Appearance&Dimension
3. 应用说明 Application Explanation
4. 电气特性 Electrical Characteristics
5. 射频性能 RF Performance
6. 认证与法规信息 Certificate&Regulation
7. 包装与订货说明 Package& Ordering information
8.
环保声明
Green Policy
TCL 通力电子(惠州)有限公司
惠州 TCL 音视频电子有限公司
深圳市通力科技开发有限公司
法律声明
Legal Notice,Disclaimer,Copyright
文档变更说明
Table of contents
目录
目录
Document Revision History
版本:V1.0
生效日期:2018-05-31
Table of Contents
- 4 -
Page 5
EXM1020D Module Datashee
Fully qualified Bluetooth version 4.2 low Energy Module
Command interface API over SPI
Device Firmware Upgrade (DFU) over SPI or Over the Air (OTA)
Remote commands over the air
32KHz and 16MHz crystal or system clock
10-bit auxiliary ADC
1 analogue AIOs
UART
I2C/SPI for EEPROM / flash memory ICs and peripherals
Environmentally friendly, RoHS compliant
TCL 通力电子(惠州)有限公司
惠州 TCL 音视频电子有限公司
深圳市通力科技开发有限公司
版本:V1.0
生效日期:2018-05-31
1.系统概览 System Overview
1.1 通用说明 General Descriptions
Bluetooth Low Energy Module provides a highly integrated solution for delivering low power
Bluetooth v4.2 solutions. The advanced command interface offers rapid time to market.
Bluetooth Low Energy complies with Bluetooth specification version V4.2.It integrates RF , a
baseband controller , command API processor , making it a complete Bluetooth Low Energy
Solution.
Bluetooth Low Energy can be with either low cost microcontroller for intelligent Bluetooth low
energy applications. For simple sensor applications, the Bluetooth Low Energy internal scripting
capabilities enable basic functions to be implemented without the need for external host MCU
or software development tools.
1.2 性能特点 Features
- 5 -
Page 6
EXM1020D Module Datashee
TCL 通力电子(惠州)有限公司
惠州 TCL 音视频电子有限公司
深圳市通力科技开发有限公司
1.3 系统框图 Block Diagram
CSR1020
BT RF
版本:V1.0
生效日期:2018-05-31
PIO
Key/LED/Other
TX/RX
UART
SPI
Debug SPI
Flash SPI
16MB Flash
3.3V
16MHz
3V Battery
LDO
5V
- 6 -
Page 7
EXM1020D Module Datashee
- 7 -
PIN NO.
Symbol
Description
Function
1
VDD_5V1
5V input point
Power
2
GND1
Ground
Power
3
GND2
Ground
Power
4
TM4
5V input point
Power
5
2A_BAT+1
Battery 3V input
Power
6
2A_BAT+2
Battery 3V input
Power
7
2A_BAT-1
Battery 3V Ground
Power
8
2A_BAT-2
Battery 3V Ground
Power
9
VDD_3_3V
Battery 3.3V input
Power
10
VDD_FLASH
Flash power point
Test power
11
PIO[14]1
Key test point
Test power
12
AIO1
ADC test point
Test power
13
PIO8_TX
UART TX or Programmable I/O
O
14
PIO9_RX
UART RX or Programmable I/O
I
15
PIO11
Programmable I/O
I/O
16
PIO12
Programmable I/O
I/O
17
PIO13
Programmable I/O
I/O
18
MISO
SPI data output or Programmable I/O
O
19
MOSI
SPI data input or Programmable I/O
I
20
CLK1
SPI clock or Programmable I/O
I/O
21
CS1
SPI select or Programmable I/O
I
22
PIO#1
Selects debug or programmable I/O,
Pull-High: SPI debug
Pull-Down: Programmable I/O line,
default is
I
TCL 通力电子(惠州)有限公司
惠州 TCL 音视频电子有限公司
深圳市通力科技开发有限公司
版本:V1.0
生效日期:2018-05-31
2. 产品描述 Production Description
Fully qualified Bluetooth version 4.2 Low Energy Module
ASCII command interface API over UART
Module can be welded on PCB board
Environmentally friendly, RoHS compliant
Device Firmware Upgrade(DFU) over UART or Over the Air (OTA)
Remote commands over the air
Antenna ready
This device complies with RSS247 of Industry Canada. Cet appareil se conforme à
RSS247 de Canada d'Industrie. This device complies with Industry Canada licenseexempt RSS standard(s). Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the
device. appareils radio exempts de licence. Son fonctionnement est sujet aux deux
conditions suivantes: (1) le dispositif ne doit pas produire de brouillage
prejudiciable, et (2) ce dispositif doit accepter tout brouillage recu, y compris un
brouillage susceptible de provoquer un fonctionnement indesirable.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme a la norme NMB-003 du
Canada.
The device should be installed and operated with a minimum distance of 20cm between the
radiator and your body.
L'appareil doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateu
et votre corps.
For FCC:
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
“The device must not be co-located or operating in conjunction with any other
antenna or transmitter.”
Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement Caution: To maintain compliance with the
FCC’s RF exposure guidelines, place the product at least 20cm from nearby persons.
FCC Conditions
This device complies with part 15 of the FCC Rules.Operation is subject to the following two
conditions:
1.This device may not cause harmful interference.
2.This device must accept any interference received, including interference that may cause
undesired operation.
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.