TCL TRF-275W, TRF-305W, TRF-315W DisassemblyManual

TCL Home Appliances (HeFei) Co., Ltd.
Refrigerator
Disassembly Manual
Product model: TRF-275W/305W/315W
Guidelines
Required tools:
2. A Phillips screwdriver
3. A sleeve (size: 8mm)
4. Pincer pliers
Disassembly Guide
A pair of white gloves A Phillips
screwdriver (electric)
A sleeve (size: 8mm) Pincer pliers
2
Disassembly Guide
Disassembly guidelines for refrigerator chamber door
1. Use a Phillips screwdriver to first remove two screws from the upper hinge cover, and then remove the hinge cover (operated by stepping on a small step stool)
2. Use an 8mm sleeve to loosen three screws of the upper hinge, and then unscrew them with the Phillips screwdriver
3. Loosen the communication wiring harness terminal and remove the upper hinge
4. Remove the refrigerator door upwards
3
Disassembly Guide
Disassembly guidelines for freezer door
1. Use an 8mm sleeve to loosen two screws of the middle hinge, and then unscrew them with a Phillips screwdriver;
2. After removing the middle hinge, lift the freezer door upwards slightly and remove it;
4
Disassembly Guide
Step I: Remove the 2 screws at the rear of the assembly
Disassembly of the top light
Step II: Pull down the top light from the rear as shown in the figure, and unplug the 4 connecting terminals
5
State after the disassembly
Disassembly Guide
Step I: Disassemble the refrigerating air duct assembly from the top down
Disassembly of Refrigerating Chamber air duct assembly
Step II: Disassemble the refrigerating air duct assembly from the refrigerator, as shown in the diagram, and unplug the connecting terminals
6
Disassembly Guide
Step I: Use a screwdriver to remove the fixing screws of freezing air duct;
Disassembly of freezing air duct component
Step II: Pull out the air duct from below; Step III: Unplug the freezing air duct terminal
and take out the freezing air duct;
7
Disassembly Guide
Step I: Use a screwdriver to remove the fixing screws of evaporator;
Disassembly of freezing evaporator
Step II: Use pincer pliers to cut off the evaporator tube and remove the evaporator;
8
Disassembly Guide
Step I: Use pincer pliers to cut off all the high and low pressure pipelines of the compressor chamber;
Disassembly of compressor chamber
Step II: Use an 8mm sleeve and a Phillips screwdriver to loosen four fixing screws on the bottom of the compressor, and then remove the compressor floor;
9
Step III: Use an 8mm sleeve and a Phillips screwdriver to remove fixing screws on the bottom of the compressor, and finally remove the compressor;
Loading...