Page 1
TCL Home Appliances (HeFei) Co., Ltd.
Refrigerator Disassembly and
Recycling Manual
Product model: TRF-210
Page 2
Guidelines
Required tools:
1. A pair of white gloves
2. A Phillips screwdriver
3. A sleeve (size: 8mm)
4. Pincer pliers
Disassembly Guide
A pair of white gloves A Phillips
screwdriver (electric)
A sleeve (size: 8mm) Pincer pliers
2
Page 3
Disassembly Guide
Disassembly guidelines for refrigerator chamber door
1. First disassemble the
upper hinge (the figure
shows the appearance of
the upper hinge)
6. Remove the upper
hinge
2. Pull the hinge cover
upwards to open
forcefully
5. The state after the
bolts are removed
3. Use an 8mm sleeve to
loosen three screws of
the upper hinge
4. Remove the bolts with
a cross screwdriver
7. Gently lift up and remove the
refrigerator chamber door
8. Complete the disassembly of the
refrigerating chamber door
3
Page 4
Disassembly Guide
Disassembly guidelines for freezer door
1. First disassemble the
middle hinge and open
the freezer chamber door
6. Complete the
disassembly of the freezer
chamber door
2. Use an 8mm sleeve to
loosen two screws of the
middle hinge
5. After removing the
middle hinge, gently lift
up and remove the
freezer chamber door
4
3. Remove the bolts with a
cross screwdriver
4. Remove the middle
hinge (In this process, it is
necessary to hold the
door firmly)
Page 5
Disassembly Guide
Disassembly of the temperature control lamp assembly
1. Appearance of
temperature control
lamp assembly
6. Unplug the plug
terminal connected
to the thermostat
2. Use a cross screwdriver to
remove the screws on the
temperature control lamp
5. Unplug the wire harness
connection terminal on the
thermostat
3. Remove the
temperature control lamp
assembly by hand
4. Pull out the wire
harness of the thermostat
from the inside of the box
7. Remove the temperature
control lamp assembly
8. The state of the temperature control
lamp assembly after disassembly
5
Page 6
Disassembly Guide
Disassembly of the bottom adjusting foot
1. Appearance of
bottom adjusting foot
6. Complete the
disassembly of the bottom
adjusting foot
2. Use an 8mm sleeve to
loosen two screws of the
lower hinge
5. Remove the bottom
adjusting foot by hand
6
3. Remove the bolts with a
cross screwdriver
4. Use a cross screwdriver
to remove the other bolt
Page 7
Disassembly Guide
1. Prepare to disassemble the
water tray of the compressor
compartment
2. Use a cross screwdriver to
disassemble the screw at one
end of the lower water tray
compartment
4. Remove the water tray of the
compressor compartment
Disassembly of the water tray of the compressor
7
3. Use a cross screwdriver to
disassemble the screw at the other
end of the lower water tray
Page 8
Disassembly Guide
Step I: Use pincer pliers to cut off all the high and low
pressure pipelines of the compressor chamber;
Disassembly of compressor chamber
Step II: Use an 8mm sleeve and a Phillips
screwdriver to loosen four fixing screws on the
bottom of the compressor, and then remove the
compressor floor;
8
Step III: Use an 8mm sleeve and a Phillips
screwdriver to remove fixing screws on the
bottom of the compressor, and finally
remove the compressor;
Loading...