Compliance notice
Declaration of conformity
Disposal of your old product and battery
12 Notice for US and Canada 9
Compliance notice for US
Compliance notice for Canada
13 Trademarks 10
1 Important safety
instructions
Hearing Safety
Danger
To avoid hearing damage, limit the time you use
earphones at high volume and set the volume to a
safe level. The louder the volume, the shorter the safe
listening time is.
To prevent accidents and damage to ears:
• Listen at reasonable volumes for reasonable periods of
time.
• Be careful not to adjust the volume continuously upwards
as your hearing adapts.
• Do not turn up the volume so high that you can’t hear
what’s around you.
Caution:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Operating temperature and humidity:
• Operate or store in a place where temperature is between
0ºC (32ºF) to 45ºC (113ºF) (up to 90% relative humidity
with no condensation).
• Battery life may be shorter in high or low temperature
conditions.
Charging temperature
Charging with the charging case when temperature is
between 0ºC (32ºF) to 45ºC (113ºF)
Medical device
The earphones and charging case contain magnets. The
American Heart Association (US) and the Medicines and
Healthcare Products Regulatory Agency (UK) both warn that
magnets can affect the operation of implanted pacemakers,
cardioverters, defibrillators, insulin pumps or other electro
medical devices (collectively, "Medical Device") within the
range of 15 cm (6 inches). If you are a user of any of these
Medical Devices, DO NOT USE THIS EARPHONES AND
CHARGING CASE UNLESS YOU HAVE CONSULTED WITH
YOUR PHYSICIAN.
General safety information
To prevent damage and malfunctions:
• Do not expose earphones to excessive heat.
• Do not drop your earphones.
• The earphones are resistant to dripping and splashing
water. The charging case is not waterproof. Before putting
the earphones into the charging case, thoroughly wipe off
any moisture.
• Do not submerge your earphones in water.
• Do not use any cleaning agents containing alcohol,
ammonia, benzene, or abrasives.
• If cleaning is required, use a soft cloth, if necessary
dampened with a minimum amount of water or diluted
mild soap, to clean the product.
Battery precautions:
• The integrated battery shall not be exposed to excessive
heat such as sunshine, fire or the like.
Liability:
• This product is designed for use with mobile devices that
support Bluetooth
Inc. and are compatible to the following Bluetooth® profile:
Bluetooth® profile
• HFP - Hands-free profile
• A2DP - Advanced audio distribution profile (Bluetooth
stereo supported)
• AVRCP - Audio video remote control profile
• It is considered improper use when this product is used
for any application not named in this user manual.
• TCL Corporation bears no responsibility for accidents or
damage caused by improper use of this product.
Caution:
The user is cautioned that changes or modifications not
expressly approved by the party responsible for compliance
®
standard specified by Bluetooth® SIG,
®
3
2 What’s in the box
TCL truly wireless earphones
MOVEAUDIO S200
Charging caseUSB cable (for charging)
3 First Time Use:
Activation
1. For the first time using, open, close and then open the
charging case to complete the activation.
①
②
00:04
QSG
Quick start guideSafety sheet
Safety
sheet
2. If earbuds cannot be activated successfully. Please
charge it for a while and then repeat the activation
process again.
03:00
4
4 Pairing
Google Fast Pair
(Just for Android phone 6.0+ with Google Play Service)
1. Make sure your phone is unlocked and your Bluetooth,
Google Play Services notification, and Location are on.
2. Open the charging case. Ensure earbuds and charging
case are charged and keep the case next to your phone.
3. Tap the earbuds pairing notification and follow the onscreen steps.
Nearby now
TCL MOVEAUDIO S200
Tap to pair with this device
②①
Nearby now
TCL MOVEAUDIO S200
Tap to pair with this device
5 Wearing
instruction
Place the earbuds in a forward and down position.
Manual Pairing
1. Open the wireless charging case. Ensure earbuds and
charging case are charged and keep the case next to
your phone.
2. Make sure your phone is unlocked and your Bluetooth is
on.
3. Select TCL MOVEAUDIO S200 from your phone’s
Bluetooth menu - available Bluetooth devices.
90%90%
Bluetooth
Bluetooth
TCL MOVEAUDIO S200
90%
Bluetooth
5
6 Connect to other
90%
devices
Press and hold the pairing button on the back of the
charging case for 2 seconds. When the charging case light
starts blinking white, it means the earbuds turn into pairing
mode, and you can select TCL MOVEAUDIO S200 from
your phone’s Bluetooth menu-available Bluetooth devices.
①②
7 Charge
Charge Earbuds
Place the earbuds in the case to charge.
①
00:02
Bluetooth
②
③
Charge Case
Charge the case with the USB-C cable and a standard 5V
DC USB Charger for about 2 hours to full.
2 HR
6
8 Touch Control
9 LED Light
Before you can make calls and enjoy music with your
earphones, follow the instructions below to set up and
connect your earphones.
Siri/Google assistant...
00:02
Indications
The LED light indicates the charge of the earbuds when you
put in or take out the buds. When pressing the button or
opening/closing the lid will indicate charge remaining in the
case
Charging
=100%
>
Fully charged
Earbuds battery
<50%
<50% power
Earbuds battery
≥50%
≥50% power
00:02
<10%
Charging case battery
<50%
<50% power
Charging case battery
≥50%
≥50% power
7
10 Reset
<50%
<10%
≥50%
11 Notice
Place the earbuds into the charging case and keep it open,
press and hold the button on the case for 10 seconds until
the amber LED blinks. The earbuds have been restored to
their factory settings, and they will then enter Pairing mode
with white LED blinks.
①
②
00:10
X3
Compliance notice
EMF
This product complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
Declaration of conformity
Hereby, TCL Corporation declares that this product is
in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU. You can find
the Declaration of Conformity on www.tcl.com
Disposal of your old product
and battery
Environmental protection and sustainability
We have omitted all unnecessary packaging and make sure
it is eco-friendly and sustainable.
Your product is designed and manufactured with
high quality materials and components, which can
be recycled and reused. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old equipment.
For recycling information, please visit www.tcl.com
This symbol on a product means that the product
is covered by European Directive 2012/19/EU.
This symbol means that the product contains a
built-in rechargeable battery covered by European
Directive 2013/56/EU which cannot be disposed of
with normal household waste. We strongly advise
you to take your product to an official collection
point.
8
12 Notice for US
and Canada
Compliance notice for US
This device complies with the FCC rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
FCC rules
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Compliance notice for Canada
This device complies with Industry Canada licenceexempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
CAN ICES-3(B)/NMB-3(B)
IC Radiation Exposure Statement
This equipment complies with Canada radiation
exposure limits set forth for uncontrolled environments.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Caution: The user is cautioned that changes or
modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. This transmitter
must not be co-located or operated in conjunction with any
other antenna or transmitter.
9
13 Trademarks
The Bluetooth® word mark and logos are registered
trademarks owned by Bluetooth
such marks by TCL Corporation under license.
®
Siri
Siri® is a trademark of Apple Inc., registered in the U.S.
and other countries.
Google™
Google™ and the Google™ Logo are registered trademarks
of Google™ Inc., and Google Assistant™ is a trademark of
Google™, Inc.
USB Type-C™
USB Type-C™ is a trademark of USB Implementers Forum.
TCL
TCL is a registered trademark of TCL Corporation in the U.S.
and Canada.