TBC AKP 200 User Manual

MOUNTING PROCEDURE

Please keep the procedure as follows

1. Components

2. Mounting Procedure

1. Before you beginning

- Manufacturer and Seller do not provide vehicle wiring information for each car,
since there are many different makes and models of vehicles.

- The principle of AnyKey sends the pulse signal to lock or unlock the door.

- Recommend to inquire of and install at local car service centers. (remote engine start,
car security, car alarms)

- For DIY, please find vehicle wiring diagram at web. (Site may vary due to web owner)
ex) http://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.aspx
http://www.the12volt.com/installbay/vehicles.html

Keypad Main unit wire

connect the signal line (Brown or Orange) to the lock or unlock power line of

App. Working range

Manual

So don't

vehicle.

INSTALLATION MANUAL

2. Product Wires Mapping

Pin Color Description

1 Black (-) System Ground Input

2 Red

3 Brown (-) Unlock Signal Output

4 Orange (-) Lock Signal Output

5 *Blue (-) Aux 1 output for Engine lock (as option)

6 *White (-) Aux 2 output for Engine lock (as option)

3. Find the three lines and ground in your car and connect to the wires from the harness.

- Lines: +12V constant Power, Power lock signal, Power unlock signal

- Ground: Connect the Black wire from the harness to the clean chassis ground

4. Plug the connector from harness to the main unit and check the operation status.

- After plug it flash 3 times.

- In case of no touch response, unplug the connector, re-connect it or check the
connection. (initial one time to adjust the sensitivity)

- If proper operation, Unplug the connector

5. Keypad placement

- Clean and wipe the location for the keypad on the windshield

- If the glass is tinted, it is recommended that you cut off the keypad size and attach the
main unit on it.

- Peel off the red protective vinyl on the keypad.

- Attach the keypad at the centre of the A-pillar of the front windshield near driver’s seat.

→ The direction of #1/2 is downside, and #9/0 are upside (Left side handle)
→ The direction of #9/0 is downside, and #1/2 are upside (Right side handle)

- Please make sure to affix the keypad completely to avoid air bubble forming

(+12V) System Power Input (at Key box)

*Tip!!! for easy and neat affixing the sheet onto
the windshield,

1) Dip it fully into water in a cup.

2) Place it onto windshield.

3) Then, you can move it flexibly and position it
properly

4) Sweep it gently with plastic card from up to
down to let water drip

5) Leave it over 30 minutes and let it get dry so
as to be firmly affixed.