Tatung TVA-171 User Manual
T
R
I
V
I
E
W
Pole Mount Kit TPM-
Installation Instructi
on
155
Because pole situation vary from job to job, it is m
engineer
l
W
AR
N
I
N
G
THIS MOUNT KIT USED FOR LCD MONITOR
THAT
VESA STANDARD IS 75MM.
1. Parts in the assembly:
(1) Dual-pivot assembly (1 assy).
(2) Pole plate (1 piece).
(2-1) Stainless steel strap, (2 pcs)
(3) Screws, hex
(4) Screws, hex
(5) ABS caps, incl
(6) Adjustable screw se
2. Tools
3
a. Use two stainless steel straps (2-1) to install Pole
plate (2) onto pole,
2". Consult with local
t
right
screws
c. Use screws (4) to install LCD monitor on the
t
it until the monitor can swivel freely and stay at
needed: Wrench, Screw driver.
. Installation:
b. Use screw (3) to install Dual-pivot assembly (1) on
he Pole plate (2) al
illustration. Do not use over-force, fastening
Dual-pivot assembly (1).
d
. If it is necessary to adjust the screw set (6), firs
ake off ABS caps
desirable angle firmly.
e. W
hen adjustment done, put 4 ABS caps back
head, ph
head
uded in assembly (1).
gently.
, t
oads. Pole must be m
l
oad 16 lb., monitor TLM-1503, TLM-1505 and TLM-1703 recomm
Do not use over force on the screws during installation
illips, 1/4"-20, 16mm L (4pcs
ph
illips
,
, M4x0.7, 12mm L (4pcs)
t, incl
uded in assembly (1).
applicable pole diameter 1.5"
engineer for pr
ong the proper direction, refer to
hen tighten or loos
and architect to ensure that the mounting brackets are pr
oper moun
ade of metal material and applicable pole diameter is 1.5 ~ 2.0 inch. Maximum
t.
t
en
.
-
)
.
andatory that you consult with
.
To Back of
Monito
r
75MM
This
4
rizontal
ho
the
operly mounted to handle the applied
ended
.
1
This
vertica
end
3
appropriate local
2
end
l
2-1
POL
E
* To take off ABS caps from Dual-pivot assembly, firs
move the cap al
metal plate, t
"B", refer to the figure below. Similarly steps for res
caps.
Reverse the
TATUNG COMPANY OF AMERICA, I
2850 EL PRESIDIO ST, LONG BEACH, CA 90810
TEL: 310.637.2105 FAX: 310.631.4758
ong the direction "A" until touching t
hen pull the cap up along the directi
above steps for installing the caps back
B
A
NC
on
t
t
he
.
6
Dual-pivot Assembl
5
y
Loading...