IF-AN16/OUT
Nov, 2016
Product Spec Sheet
ANALOG OUTPUTS INTERFACE CARD
IF-AN16/OUT
■ Specifications
Ratings
・Formats and channels
16 channels at 44.1/48/88.2/96kHz, 16-bit/24-bit
Analog audio output ratings
・ANALOG 1-8 / 9-16 OUT connectors
Connector: D-Sub 25-pin
Locking screws: No. 4-40 UNC (inch type)
Nominal output levels: +4 dBu, +6 dBu (only when maximum output level is +15 dBu)
Maximum output levels: +24 dBu, +22 dBu, +20 dBu, +18 dBu, +15 dBu
(Switched according to nominal level of device installed in)
Output impedance: 200 Ω or lower
Output attenuation: 0 to −14 dB (in 0.5dB steps)
•Applicable load impedance:2 kΩ or higher
•0dBu = 0.775Vrms
Audio performance
・Frequency response
+0.1 dB/-0.5 dB: 20 Hz/20 kHz (-16 dBFS input, 44.1/48kHz sampling frequency, JEITA)
+0.1 dB/-1.0 dB: 20 Hz/40 kHz (-16 dBFS input, 88.2/96kHz sampling frequency, JEITA)
・Distortion (THD+N)
0.001% or less
(0 dBFS input, 1kHz, 44.1/48/88.2/96kHz sampling frequency, JEITA)
・S/N ratio
110 dB or higher
(44.1/48/88.2/96kHz sampling frequency, JEITA)
0040a -1- TEAC CORPORATION
IF-AN16/OUT
・Dynamic range
110 dB or higher
(44.1/48/88.2/96kHz sampling frequency, JEITA)
・Crosstalk
110 dB or higher
(1 kHz, 44.1/48/88.2/96kHz sampling frequency, JEITA)
•When output attenuation set to 0 dB
Other
・Dimensions
107 x 40 x 161.5 mm (width × height × depth, including protrusions)
・Weight
240g
■ Dimensional drawings
_________________________________________________________________________________________________________________________________________________
※TASCAM is trademark of TEAC CORPORATION, registered in the U.S. and other countries.
※Other company names, product names and logos are the trademarks or registered trademarks of their owners.
※Specifications and appearance are subject to change without notice.
※All information included in this document is as of Nov, 2016.
0040a -2- TEAC CORPORATION