Targus USB Retractable Calculator Keypad User Manual

Visit our Webs ite at www.targu s.com
Features and specifications subject to change without notice.
©2006 Targus Group I nternational , Inc. and Targus, I nc.

PAUK001U / 410-0 240-001A

USB
Retractable
Calculator Keypad

USER GUIDE

TARGUS USB

2

RETRACTABLE

CALCULATOR

KEYPAD

Introduction

Congratulations on your purchase of the Targus USB retractable
calculator keypad. This versatile accessory connects to your
computer’s Universal Serial Bus (USB) port and uses a two-way power
system, incorporating both power from your computer and one A3,
LR41 or V3GA “button” battery. It enables you to:

• Perform standard calculator operations

• Send calculation results to the cursor location in the active
program on your computer (calculator mode only)

• Enter numbers and control cursor movement as you would from
a standard keypad

System Requirements

Hardware

• PC with an Intel® Pentium® processor or equivalent

• USB version 1.1 interface

Operating System

• Windows® 98/Me/2000/XP

• Windows Vista™

Targus USB retractable calculator keypad

3

Connecting the Calculator Keypad to Your
Computer

1. Plug one end of the retractable USB cable into the port on the
keypad and extend the cable to the desired length.

Calculator/Keypad - back view

2. Plug the other end of the USB cable into an available USB port on
your computer.

3. You are now ready to install the keypad driver.

Installing the Default Driver

After connecting the Calculator/Keypad to your computer, you are
ready to install the default driver supplied with the operating system. To
do this, follow the procedure listed below for your operating system.

Targus USB retractable calculator keypad

4

Windows 98/Me Operating Systems

1. The Add New Hardware Wizard appears. If it does not, the operating
system has installed the default driver automatically. No other steps
are necessary.

2. Click Next.
The locate driver screen appears.

3. Select “Search for the best driver for your device. (Recommended),”
and then click Next.
The wizard searches for the appropriate device driver.

4. Click Next.

5. Click Finish to complete the driver installation.

You are now ready to begin using your Calculator/Keypad.

Windows 2000/XP/Vista Operating Systems

1. The Found New Hardware Wizard appears.
If it does not, the operating system has installed the default driver
automatically. No other steps are necessary.

2. Click Next.
The wizard searches for the appropriate device driver.

3. Click Next.

4. Click Finish to complete the driver installation and you are now
ready to begin using your Calculator/Keypad.

Targus USB retractable calculator keypad

5

Using the Calculator/Keypad

Turning the Keypad Off and On

To turn on the Calculator/Keypad, press the CE/AC key, located
directly above the number seven key. The keypad starts in calcula­tor mode and displays “0.”

The Calculator/Keypad automatically turns itself off after three
minutes and 50 seconds of non-operation. There is no “off ” key.

Switching Between Calculator and
Keypad Mode

This Targus accessory operates as a calculator or as a keypad.
When the device is in calculator mode, the LED indicator light,
located next to the NRC key, does not glow. When the device is in
keypad mode, the LED glows green. To switch between the two
modes, press the MODE key.

NOTE: THE NUMLOCK KEY ON YOUR COMPUTER WILL NOT AFFECT THE NUMLOCK
STATUS OF THE CALCULATOR/KEYPAD.