Tap Magic 67040C User Manual

Tap Magic
Formula 2 Eco-Oil
SECTION 1: Identification of the substance/mixture and of the supplier
Product name:
Tap Magic Formula 2 Eco-Oil
Manufacturer/Supplier Article number:
60016C, 60128C, 60640C, 6384 0C, 67040C
Special Notes on Product uses:
After use of this product, clean and lubricate metal surfaces to avoid staining and/or corrosion.
Recommended uses of the product:
Machining, Cutting, Tapping, and Metal Processing.
Manufacturer/Supplier Details:
Email: steco@tapmagic.com
Emergency telephone number: ChemTel Inc.: (800)255-3924, +1 (813)248-0585
SECTION 2: Hazards identification
Unknown Acute Toxicity: Less than 0.1% of ingredients are of unknown acute toxicity.
NFPA/HMIS
NFPA SCALE (0-4)
1
HMIS SCALE (0-4)
FIRE
1
0
SECTION 3: Composition/information on ingredients
0 1
1
The Steco Corporation 2330 Cantrell Road
Little Rock, AR 72202 USA
Tel: 501-375-5644 Website: www.tapmagic.com
Safety Data Sheet
Page 1 of 7
Classification of the substance or mixture: Not classified under GHS. Signal word: None. Hazard statements: None. Precautionary statements: None. Hazards Not Otherwise Classified (HNOC): None.
Health = 1
Fire = 1
Reactivit y = 0
0=Minimal Hazard; 1=Slight Hazard; 2=Moderate Hazard; 3=Serious Hazard; 4=Severe Hazard.
Chemical characterization: Mixture. Description: Machining, cutting, tapping, and metal processing. Hazardous components:
None.
HEALTH
PHYSICAL HAZARD
Health = 1*
Fire = 1
Physical Hazar d = 0
SECTION 4: First aid measures
Description of first aid measures
General information:
Take affected persons into fresh air, if feasible, or away from the source. Consult a doctor/physician if concerned or feel unwell. Immediately remove any clothing soiled by the product. In case of irregular breathing or respiratory arrest, provide artificial respiration.
This SDS applies to part numbers: 60016C, 60128C, 60640C, 63840C, 67040C
Safety Data Sheet
Tap Magic
Formula 2 Eco-Oil
SECTION 6: Accidental release measures
After inhalation:
Supply fresh air; consult doctor in case of complaints. If aspirated, seek medical attention immediately. Provide oxygen treatment if affected person has difficulty breathing.
After skin contact:
Immediately wash with water and soap and rinse thoroughly. If skin irritation continues, consult a doctor.
After eye contact:
Remove contact lenses if worn. Rinse opened eye for at least 15 - 20 minutes under running water. If symptoms persist, consult a doctor.
After swallowing:
Rinse out mouth and then drink plenty of water. Call for medical help immediately. Do not induce vomiting. If victim vomits, be sure to keep head below knees to prevent aspiration of vomitus into lungs. If victim is unconscious, position on their side and support them so they cannot roll onto their back.
Most important symptoms and effects, both acute and delayed:
Breathing difficulty. Coughing. Irritant to skin, eyes and mucous membranes. Gastric or intestinal disorders when ingested.
Hazards:
Danger of impaired breathing. May cause respiratory irritation.
Indication of any immediate medical attention and special treatment needed:
Consult a doctor/physician if concerned or feel unwell.
SECTION 5: Firefighting measures
Page 2 of 7
Extinguishing media
Suitable extinguishing agents:
Use an extinguishing agent suitable for the surrounding fire. Foam. Carbon Dioxide. Dry Chemical.
For safety reasons unsuitable extinguishing agents: Special hazards arising from the substance or mixture: Carbon monoxide.
Advice for firefighters
Protective equipment:
Use self-contained breathing apparatus (SCBA) and full bunker turnout gear in a sustained fire. Wear fully protective suit.
Hazardous Combustion Products:
Incomplete combustion is likely to give rise to a complex mixture of airborne solid and liquid particulates and gases, including carbon monoxide and unidentified organic and inorganic compounds.
Additional information:
Cool endangered receptacles with water fog or haze. Use large quantities of foam as it is partially destroyed by the product.
None known.
Personal precautions, protective equipment and emergency procedures:
Use respiratory protective device against the effects of release. Wear protective equipment. Keep unprotected persons away. Ensure adequate ventilatio n.
This SDS applies to part numbers: 60016C, 60128C, 60640C, 63840C, 67040C
Safety Data Sheet
Tap Magic
Formula 2 Eco-Oil
SECTION 8: Exposure controls/personal protection
Safety glasses
Protective gloves
Particular danger of slipping on leaked/spilled product.
Environmental precautions:
For small spills, soak up with shop towels or absorbent material such as oil-dry or vermiculite. For large spills, any leaks should be stopped. Spill should be contained, then cleaned up using vacuum truck or absorbent material.
Methods and material for containment and cleaning up:
Absorb with non-combustible liquid-binding material (sand, diatomite, acid binders, universal binders). Pick up mechanically. Send for recovery or disposal in suitable receptacles. Dispose contaminated material as waste according to Section 13.
Reference to other sections:
See Section 7 for information on safe handling. See Section 8 for information on personal protection equipment. See Section 13 for disposal information.
SECTION 7: Handling and storage
Page 3 of 7
Precautions for safe handling:
Prevent formation of aerosols. Avoid splashes or spray in enclosed areas. Use only in well ventilated areas. Keep from freezing. **After use of this product, clean and lubricate metal surfaces to avoid staining and/or corrosion.
Conditions for safe storage, including any incompatibilities
Storage: Requirements to be met by storerooms and receptacles:
Store only in the original receptacle. Avoid storage near extreme heat, ignition sources or open flame.
Information about storage in one common storage facility:
Store away from oxidizing agents. Do not store together with alkalis/caustic solutions. Store away from foodstuffs.
Further information about storage conditions:
Store in cool, dry conditions in well-sealed containers. Store receptacle in a well-ventilated area.
Information about fire and explosion protection:
No special measures required.
Control Parameters:
Vegetable oil (Respirable fraction.) US. OSHA Z-1 PEL TWA 5 mg/m³ Vegetable oil (Total dust.) US. OSHA Z-1 PEL TWA 15 mg/m³
Exposure controls
General protective and hygienic measures:
The usual precautionary measures for handling chemicals should be followed. Keep away from foodstuffs, beverages and feed. Immediately remove all soiled and contaminated clothing. Wash hands before breaks and at the end of work. Avoid contact with the eyes and skin. Do not inhale gases / fumes / aerosols.
:
This SDS applies to part numbers: 60016C, 60128C, 60640C, 63840C, 67040C
Loading...
+ 4 hidden pages