Tap Magic 60012CL User Manual

Tap Magic

Formula 2 Eco-Oil (Aerosol)

SECTION 1: Identification of the substance/mixture and of the supplier

Product name:

Tap Magic Formula 2 Eco-Oil (Aerosol)

Manufacturer/Supplier Article nu m b er :

60012CL

Special Notes on Product uses:

After use of this product, clean and lubricate metal surfaces to avoid
staining and/or corrosion.

Recommended uses of the product:

Machining, Cutting, Tapping, and Metal Processing.

Manufacturer/Supplier Details:

The Steco Corporation

Email: [e-mail]

Emergency telephone number: ChemTel Inc.: [phone], [phone]

SECTION 2: Hazards identification

Unknown Acute Toxicity: Less than 0.1% of ingredients are of unknown acute t ox icity.

NFPA/HMIS

NFPA SCALE (0-4)

1

HMIS SCALE (0-4)

FIRE

1

0

SECTION 3: Composition/information on ingredients

0 1 1

2330 Cantrell Road

Little Rock, AR 72202 USA

Tel: [phone]
Website: www.tapmagic.com

Safety Data Sheet

Page 1 of 7

Classification of the substance or mixture:

GHS04: Gas under pressure

Dissolved gas; H280

Signal word: Warning.
Hazard statements:

H280: Contains gas under pressure, may explode if heated.

Precautionary statements:

P410+P403: Protect from sunlight . Store in a well-ventilated place.

Hazards Not Otherwise Classified (HNOC): None.

Health = 1

Fire = 1

Reactivit y = 0

0=Minimal Hazard; 1=Slight Hazard; 2=Moderate Hazard; 3=Serious Hazard; 4=Severe Hazard.

HEALTH

PHYSICAL HAZARD

Health = 1*

Fire = 1

Physical Hazar d = 0

Chemical characterization: Mixture.
Description: Machining, cutting, tapping, and metal processing.
Hazardous components:

CAS / Identifying No. Description Wt. %

CAS: 124-38-9

As listed below.

Carbon Dioxide

Pressurized gas-Dissolved gas H280

This SDS applies to part numbers: 60012CL

0 – 5%

Safety Data Sheet

Tap Magic

Formula 2 Eco-Oil (Aerosol)

SECTION 4: First aid measures

SECTION 5: Firefighting measures

Description of first aid measures

General information:

Take affected persons into fresh air, if feasible, or away from the source.
Consult a doctor/physician if concerned or feel unwell.
Immediately remove any clothing soiled by the product.
In case of irregular breathing or respiratory arrest, provide artificial respiration.

After inhalation:

Supply fresh air; consult doctor in case of complaints.
If aspirated, seek medical attention immediately.
Provide oxygen treatment if affected person has difficulty breathing.

After skin contact:

Immediately wash with water and soap and rinse thoroughly.
If skin irritation continues, consult a doctor.

After eye contact:

Remove contact lenses if worn.
Rinse opened eye for at least 15 - 20 minutes under running water. If symptoms persist, consult a doctor.

After swallowing:

Rinse out mouth and then drink plenty of water.
Call for medical help immediately.
Do not induce vomiting.
If victim vomits, be sure to keep head below knees to prevent aspiration of vomitus into lungs.
If victim is unconscious, position on their side and support them so they cannot roll onto their back.

Most important symptoms and effects, both acute and delayed:

Breathing difficulty.
Coughing.
Irritant to skin, eyes and mucous membranes.
Gastric or intestinal disorders when ingested.

Hazards:

Danger of impaired breathing.
May cause respiratory irritation.

Indication of any immediate medical attention and special treatment needed:

Consult a doctor/physician if concerned or feel unwell.

Page 2 of 7

Extinguishing media

Suitable extinguishing agents:

Use an extinguishing agent suitable for the surrounding fire.
Foam.
Carbon Dioxide.
Dry Chemical.

For safety reasons unsuitable extinguishing agents:
Special hazards arising from the substance or mixture: Carbon monoxide.

Advice for firefighters

Protective equipment:

Use self-contained breathing apparatus (SCBA) and full bunker turnout gear in a sustained fire.
Wear fully protective suit.

Hazardous Combustion Products:

Incomplete combustion is likely to give rise to a complex mixture of airborne solid and liquid particulates and
gases, including carbon monoxide and unidentified organic and inorganic compounds.

Additional information:

Cool endangered receptacles with water fog or haze.
Use large quantities of foam as it is partially destroyed by the product.

None known.

This SDS applies to part numbers: 60012CL

Safety Data Sheet

Tap Magic

Formula 2 Eco-Oil (Aerosol)

SECTION 6: Accidental release measures

SECTION 7: Handling and storage

Personal precautions, protective equipment and emergency procedures:

Use respiratory protective device against the effects of release.
Wear protective equipment.
Keep unprotected persons away.
Ensure adequate ventilatio n.
Particular danger of slipping on leaked/spilled product.

Environmental precautions:

For small spills, soak up with shop towels or absorbent material such as oil-dry or vermiculite.
For large spills, any leaks should be stopped.
Spill should be contained, then cleaned up using vacuum truck or absorbent material.

Methods and material for containment and cleaning up:

Absorb with non-combustible liquid-binding material (sand, diatomite, acid binders, universal binders).
Pick up mechanically.
Send for recovery or disposal in suitable receptacles.
Dispose contaminated material as waste according to Section 13.

Reference to other sections:

See Section 7 for information on safe handling.
See Section 8 for information on personal protection equipment.
See Section 13 for disposal information.

Page 3 of 7

Precautions for safe handling:

Avoid handling or use near extreme heat, ignition sources or open flame.
Prevent release or formation of aerosols except as intended.
Avoid splashes or spray in enclosed areas.
Use only in well ventilated areas.
Prevent from freezing.
Do not spray on an open flame or other ignition source.
**After use of this product, clean and lubricate metal surfaces to avoid staining and/or corrosion.

Conditions for safe storage, including any incompatibilities

Storage:
Requirements to be met by storerooms and receptacles:

NO SMOKING in area where this product is used or stored.
Store only in the original receptacle.
Avoid storage near extreme heat, ignition sources or open flame.

Information about storage in one common storage facility:

Store away from oxidizing agents.
Do not store together with alkalis/caustic solutions.
Store away from foodstuffs.
Keep away from heat, hot surfaces, sparks, open flames and other ignition sources.
Protect from sunlight.
Do not expose to temperatures exceeding 50 °C/122 °F.

Further in

Store in cool, dry conditions in well-sealed containers.
Store receptacle in a well-ventilated area.

Information about fire and explosion protection:

Keep away from heat, sunlight, fire and ignition sources.
Do not puncture or burn container.

formation about storage conditions:

T

his SDS applies to part numbers: 60012CL