Tap Magic Formula 1 Aqueous (Aerosol)
SECTION 1: Identification of the substance/mixture and of the supplier
Tap Magic Formula 1 Aqueous (Aerosol)
Manufacturer/Supplier Article nu m b er :
Special Notes on Product uses:
After use of this product, clean and lubricate metal surfaces to avoid
Recommended uses of the product:
Machining, Cutting, Tapping, and Metal Processing.
Manufacturer/Supplier Details:
Email: steco@tapmagic.com
Emergency telephone number: ChemTel Inc.: (800)255-3924, +1 (813)248-0585
SECTION 2: Hazards identification
Unknown Acute Toxicity: <0.2% ingredients are of unknown acute toxicity
The Steco Corporation
2330 Cantrell Road
Little Rock, AR 72202 USA
Tel: 501-375-5644
Website: www.tapmagic.com
Safety Data Sheet
staining and/or corrosion.
** Tap Magic Formula 1 Aqueous must not be use d for magnesium
Page 1 of 8
Classification of the substance or mixture:
GHS02: Flammable material
Flam. aerosol 1; H222: Extremely flammable aerosol.
GHS07: Irritant.
Skin2 H315, Eye2 H319
Signal word: Danger.
Hazard statements:
H315: Causes skin irritation.
H319: Causes serious eye irritation.
Precautionary statements:
P264: Wash hands and exposed skin thoroughly after handling.
P280: Wear protective gloves/protective clothing/eye protection/face protection.
P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present
and easy to do – continue rinsing for 15-20 minutes.
P337+P313: If eye irritation persists get medical advice/attention.
P321: Specific treatment (see Section 4 on this SDS).
P362: Take off contaminated clothing and wash before reuse.
P302+P352: IF ON SKIN: Wash with soap and water.
Hazards Not Otherwise Classified (HNOC): None.
HEALTH
Health = 1
Fire = 1
0=Minimal Hazard; 1=Slight Hazard; 2=Moderate Hazard; 3=Serious Hazard; 4=Severe Hazard.
Reactivity = 0
This SDS applies to part numbers: 50012QL
FIRE
PHYSICAL HAZARD
Health = 1*
Fire = 1
Physical Hazar d = 0
Safety Data Sheet
Tap Magic Formula 1 Aqueous (Aerosol)
SECTION 3: Composition/information on ingredients
Page 2 of 8
Chemical characterization: Mixture.
Description: Machining, cutting, tapping, and metal processing.
Hazardous components:
CAS: 39464-70-5
CAS: 102-71-6
The specific chemical identity has
been withheld as a trade secret.
CAS: 68551-13-3
CAS: 68476-86-8
As listed below.
Polyethylene glycol phenyl ether phosphate
Eye1 H318; Skin 2 H315
Triethanolamine
Eye2 H319,
Amine complex trade secret
Sk1B H314; Acute tox 302, 312, 332, , STOT SE3 H335
Alcohols, C12-15, ethoxylated propoxylated
AcTox H302, H312, Eye2 H319; Aq AcTox1 H400
Propane/n-Butane
Pressurized gas (Dissolved gas) H280; Flam. gas 1 H220
SECTION 4: First aid measures
Description of first aid measures
General information:
Take affected persons into fresh air, if feasible, or away from the source.
Consult a doctor/physician if concerned or feel unwell.
Immediately remove any clothing soiled by the product.
In case of irregular breathing or respiratory arrest, provide artificial respiration.
After inhalation:
Supply fresh air; consult doctor in case of complaints.
If aspirated, seek medical attention immediately.
Provide oxygen treatment if affected person has difficulty breathing.
After skin contact:
Immediately wash with water and soap and rinse thoroughly.
If skin irritation continues, consult a doctor.
After eye contact:
Remove contact lenses if worn.
Rinse opened eye for at least 15-20 minutes under running water.
If symptoms persist, consult a doctor.
After swallowing:
Rinse out mouth and then drink plenty of water.
Call for medical help immediately
Do not induce vomiting.
If victim vomits, be sure to keep head below knees to prevent aspiration of vomitus into lungs.
If victim is unconscious, position on their side and support them so they cannot roll onto their back.
Most important symptoms and effects, both acute and delayed:
Breathing difficulty.
Coughing.
Irritant to skin and mucous membranes.
Slight irritant effect on eyes.
Gastric or intestinal disorders when ingested.
Hazards:
Danger of impaired breathing.
May cause respiratory irritation.
Indication of any immediate medical attention and special treatment needed:
Consult a doctor/physician if concerned or feel unwell.
1 – 10%
1 – 10%
<1%
1 – 10%
1 – 10%
This SDS applies to part numbers: 50012QL
Safety Data Sheet
Tap Magic Formula 1 Aqueous (Aerosol)
SECTION 5: Firefighting measures
SECTION 6: Accidental release measures
Page 3 of 8
Extinguishing media
Suitable extinguishing agents:
Use an extinguishing agent suitable for the surrounding fire.
Foam.
Carbon Dioxide.
Dry Chemical.
For safety reasons unsuitable extinguishing agents:
Special hazards arising from the substance or mixture: Carbon monoxide.
Advice for firefighters
Protective equipment:
Use self-contained breathing apparatus (SCBA) and full bunker turnout gear in a sustained fire.
Wear fully protective suit.
Hazardous Combustion Products:
Carbon oxides
Nitrogen oxides.
Additional information:
Cool endangered receptacles with water fog or haze.
Use large quantities of foam as it is partially destroyed by the product.
Personal precautions, protective equipment and emergency procedures:
Use respiratory protective device against the effects of release.
Wear protective equipment.
Keep unprotected persons away.
Ensure adequate ventilatio n.
Particular danger of slipping on leaked/spilled product.
Environmental precautions:
For small spills, soak up with shop towels or absorbent material such as oil-dry or vermiculite.
For large spills, any leaks should be stopped.
Spill should be contained, then cleaned up using vacuum truck or absorbent material.
Methods and material for containment and cleaning up:
Absorb with non-combustible liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Pick up mechanically.
Send for recovery or disposal in suitable receptacles.
Dispose contaminated material as waste according to Section 13.
Reference to other sections:
See Section 7 for information on safe handling.
See Section 8 for information on personal protection equipment.
See Section 13 for disposal information.
None known.
SECTION 7: Handling and storage
Precautions for safe handling:
NO SMOKING in area where this product is used.
Avoid handling or use near extreme heat, ignition sources or open flame.
Prevent release or formation of aerosols except as intended.
Avoid splashes or spray in enclosed areas.
Use only in well ventilated areas.
Prevent from freezing.
Do not spray on an open flame or other ignition source.
This SDS applies to part numbers: 50012QL