Tapfer 5004LTF, 5002LTF, 5001LTF, 5003LTF, 5005LTF User guide
Operating instructions
Torch
Item no. 5001LTF - Eagle 5W Torch 3 AAA
Item no. 5002LTF - Eagle 5W Torch 1 AA
Item no. 5003LTF - Eagle 5W Torch 2 AA
Item no. 5004LTF - Eagle 20W Torch 6 AA
Item no. 5005LTF - Eagle 10W Torch 18650
Intended use
The product is intended to be used as a mobile light source. The light beam can be adjusted
with the focusing wheel on the integrated lens. The brightness can be adjusted in two steps
(bright and dimmed/energy saving). The product is protected against dust and splashing water
according to IP44.
For safety and approval purposes, you must not rebuild and/or modify this product. Using the
product for purposes other than those described above may damage the product. In addition,
improper use can cause hazards such as short circuits or re. Read the instructions carefully
and store them in a safe place. Only make this product available to third parties together with
its operating instructions.
This product complies with statutory, national and European regulations. All company and
product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Torch with hand strap
• 3x AAA batteries (BN 5001LTF), 1x AA battery (BN 5002LTF),
2x AA batteries (BN 5003LTF), 6x AA batteries (BN 5004LTF)
• Operating instructions
Explanation of symbols
The symbol with an exclamation mark in a triangle is used to highlight important
information in these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on how to use the product.
• The product is protected against dust and splashing water according to IP44.
• Caution! The aperture ring has sharp edges.
• Consult a technician if you are not sure how to use or connect the product, or if
you have concerns about safety.
• Maintenance, modications and repairs may only be carried out by a technician or
a specialist repair centre.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
b) (Rechargeable) batteries
• Correct polarity must be observed while inserting the (rechargeable) battery.
• The (rechargeable) batteries should be removed from the device if it is not used
for a long period of time to avoid damage through leaking. Leaking or damaged
(rechargeable) batteries might cause acid burns when in contact with skin, therefore
use suitable protective gloves to handle corrupted (rechargeable) batteries.
• (Rechargeable) batteries must be kept out of reach of children. Do not leave
(rechargeable) batteries lying around, as there is risk, that children or pets swallow them.
• All (rechargeable) batteries should be replaced at the same time. Mixing old and
new (rechargeable) batteries in the device can lead to (rechargeable) battery
leakage and device damage.
• (Rechargeable) batteries must not be dismantled, short-circuited or thrown into
re. Never recharge non-rechargeable batteries. There is a risk of explosion!
Product overview
5003LTF
5002LTF5001LTF
5004LTF
Safety instructions
Read the operating instructions and safety information carefully. If you do
not follow the safety information and information on proper handling in these
operating instructions, we will assume no liability for any resulting personal injury
or damage to property. Such cases will invalidate the warranty/guarantee.
a) General information
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become
dangerous playing material for children.
• Protect the product from extreme temperatures, impacts, ammable gases,
vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed
if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
may damage the product.
• The product belongs to LED risk group 2. The delivery includes LED signs. If the
warning sign on the product is not in your local language, attach the corresponding
sign to the device.
• Caution, LED light:
- Do not look directly at the LED light!
- Do not look into the beam directly or with optical instruments!
• Never aim the light beam at mirrors or other reective surfaces.
• Do not point the light beam directly at people or animals. This can lead to eye or
skin injuries.
• If possible, guide the light beam so that it is not at eye level.
• The LED is permanently installed and non-replaceable.
Risk Group 2
CAUTION
This product may emit hazardous optical radiation.
5005LTF
1 Aperture ring
2 Lens
3 Focusing wheel
4 Clip
5 Battery compartment cover
6 Function switch
7 Hand strap
(not visible)
1 32 54 6
Insert the battery/remove the clip
• If the batteries are included, they are already pre-installed at delivery (For item number
5005LTF, a rechargeable battery type 18650 is required. A rechargeable battery is not
included). An insulating strip is located in the battery compartment between the contacts of
the batteries and the torch.
• Open the battery compartment by turning the battery compartment cover (5) counter-clockwise.
Remove the insulating strip.
• Replace the batteries as soon as the light beam fades or at the latest after one year. Regularly
check the batteries for leaks.
• When inserting new batteries, pay attention to the correct polarity (+/-) as indicated in the
battery compartment.
• If the clip (4) is not needed, you can remove it.
• Replace the battery compartment cover (5) on the battery compartment and turn it fully clockwise.
Operation
The housing may heat up during prolonged use. Especially with products with higher
LED power, stronger heating can occur. In this case, we recommend turning off the
torch for a short period of time (about 10 minutes) to allow it to cool down.
• The product is protected against dust and splashing water according to IP44 and may be
used indoors and outdoors. Make sure the battery compartment cover is completely closed.
• To turn on the torch, press the function switch (6). The torch lights up in bright mode.
• Briey press the function switch to dim the lights (energy-saving mode).
• Briey press the function switch again to switch to ashing light. With item no. 5004LTF, the
torch turns on the SOS signal instead of ashing light.
• You can also switch the functions mentioned above by pressing the function switch twice in
succession: bright --> energy saving mode --> ashing light (SOS signal at 5004LTF).
• Adjust the light beam by turning the focusing wheel (3).
• Press the function switch to turn off the torch.
• On the torch, there is a hand strap (7) with which the product can also be held or hung on
a hook.
• With the aperture ring (1), the torch can be turned upright on a at horizontal surface. Caution!
The aperture ring has sharp edges.
Care and cleaning
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these may
damage the casing or cause the product to malfunction.
• Do not emerge the product in water or any liquids.
• Use a lint-free cloth to clean the product. Do not press too hard on the lens (2) or housing as
this may cause scratch marks.
Technical data
Item no. 5001LTF 5002LTF 5003LTF 5004LTF 5005LTF
Power supply
LED 1x 5 W 1x 5 W 1x 5 W 1x 20 W 1x 10 W
Bright light intensity 350 lm 135 lm 300 lm 1440 lm 760 lm
Dimmed light intensity 75 lm 30 lm 65 lm 325 lm 120 lm
Light range Up to 200 m Up to 100 m Up to 150 m Up to 200 m Up to 150 m
Bright light duration Up to 3 h Up to 3.5 h Up to 5.5 h Up to 3.5 h Up to 3 h
Dimmed light duration Up to 7 h Up to 8 h Up to 10 h Up to 5.5 h Up to 7 h
Protection type IP44
Operating conditions +10 to +40 ºC, <95% RH
Storage conditions -20 to +50 ºC, <95% RH
Dimensions (W x L) 34 x 115 mm 25.5 x 106.6 mm 25.5 x 155.8 mm 45 x 169.2 mm 32 x 122 mm
Weight
(without batteries)
3x 1.5 V
AAA batteries
116 g 68 g 90 g 265 g 89 g
1x 1,5 V
AA battery
2x 1,5 V
AA batteries
6x 1,5 V
AA batteries
1x rechargeable
Battery 18650
(2200 mAh)
Disposal
a) Product
Electronic devices are recyclable waste and must not be placed in household
waste. At the end of its service life, dispose of the product according to the relevant
statutory regulations.
b) (Rechargeable) batteries
You as the end user are required by law (Battery Ordinance) to return all used
batteries/rechargeable batteries. Disposing of them in the household waste is
Contaminated (rechargeable) batteries are labelled with this symbol to indicate that
Used (rechargeable) batteries can be returned to collection points in your municipality, our
stores or wherever (rechargeable) batteries are sold.
You thus full your statutory obligations and contribute to the protection of the environment.
prohibited.
disposal in the domestic waste is forbidden. The designations for the heavy metals
involved are: Cd = Cadmium, Hg = Mercury, Pb = Lead (name on (rechargeable)
batteries, e.g. below the trash icon on the left).
Distributed by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
These operating instructions are published by CEI Conrad Electronic International (HK) Limited, 18th oor, Tower 2,
Nina Tower, no. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method (e.g. photocopying, microlming or capturing in electronic data processing systems) requires
prior written approval from the publisher. Reprinting, also in part, is prohibited. The operating instructions reect the current
technical specications at time of print.
Copyright 2018 by CEI Conrad Electronic International (HK) Limited *5001_2_3_4_5LTF_v1_0918_02_hk_m_en
Loading...