Corner Finisher
1380 Beverage Drive, Suite W
Stone Mountain, GA 30083
1-800-426-6256 | 678-892-2323
Operation and Maintenance Guide
Models: 40TT & 45TT
On models 48TT and 48XT T Only
Better – Faster – Every time
NOSE or BULLET
Updated 04 2012
NOSE or BULLET
www.tapetech.com
On models 48TT and 48XT T Only
© 2012 TapeTech Tool Co. All Rights Reserved
Corner Finisher
1380 Beverage Drive, Suite W
Stone Mountain, GA 30083
1-800-426-6256 | 678-892-2323
Models: 40TT & 45TT
Operation and Maintenance Guide
Better – Faster – Every time
Operation
The 2” and 3” corner finishers (models 40TT and 45TT) are designed to wipe
down and feather both sides of an internal corner in one pass.
They are used to follow the Corner Roller and wipe down excess compound
left when the tape is embedded into the corner. The spring action compensates for
corners that are slightly over or under 90 degrees and the blade design produces smoothly
feathered internal corners.
When using the corner finisher to wipe down internal corners after the corner roller, snap the corner
finisher onto the ball-end handle (model HF or HFRE) and use it as a plow, with the nose end leading.
Work from the bottom to the top of vertical angles and from one end to the other on ceiling angles.
Detail wall and ceiling corner intersections with a drywall knife.
After the tape coat has dried, the corner finisher is used in conjunction with the corner applicator
(model 35TT or 50TT) or the MudRunner® to apply the finish coat over the internal corners.
Snap the corner finisher onto the corner applicator or MudRunner® and fill the applicator with joint
compound. With the nose end of the corner finisher leading, start on the bottom of the vertical
corner and apply pressure to the corner applicator or twist the MudRunner® grip to start the flow of
compound, while moving the tool along the corner. About 3 feet (1 m) from the floor, release the
pressure on the corner applicator and sweep it away from the corner. Then, starting at the top of the
corner, pull the tool down the corner and release the pressure when you reach the compound left on
the previous pass. Now sweep the corner applicator and corner finisher away from the corner. Ceiling
corners are finished using the same methods.
Maintenance
Clean thoroughly after every use, with a brush and water (or a water hose) to remove all joint
compound from the tool. Then, after the tool is clean, lightly oil with Ames® Bazooka® Oil or any
light machine oil
Updated 04 2012
www.tapetech.com
© 2012 TapeTech Tool Co. All Rights Reserved
Loading...