VTH TOP HAT
Pole Mount Top Hat Accessory for VX Loudspeakers
Ø82mm [
Ø118mm [Ø4.6inch]
Ø
3.2inch]
4-Ø7.5mm [
0.30inch]
Ø
2.0mm [0.08inch]
4.4mm [0.17inch]
Installation:
1. Remove the 4 screws from the bottom of the VX speaker that hold the blanking plate in place.
2. Remove the blanking plate, then place the Top Hat xture onto the speaker so that the pole receptacle goes into the speaker box.
3. Align the screw holes over the speaker and replace the original 4 screws to complete the installation.
76mm [3.0inch]
WARNING: As the legal requirements for ying vary from country to country, please consult your local safety standards o ce before installing any product.
We also recommend that you thoroughly check any laws and bylaws prior to installation. For more detailed information on rigging hardware and safety
procedures, please consult the full VX Series Quick Start Guide.
Loading...