Tannoy IQ 10-15 User Manual

iQ SERIES

PERFORMANCE DATA AND HARDWARE INFO

iQ 10/15

NOTES:

Arraying

8.

Comb filtering is a phenomenon, which cannot be cured by equalisation. Small
alterations to loudspeaker positions can have the effect of minimising problematic
combing frequencies. Arrays should be constructed so that the individual coverage
patterns of each loudspeaker combine with minimal overlap. The design of the
iQ 10/15 cabinet greatly simplifies the creation of effective arrays, allowing seamless
wide (120 degree) horizontal coverage using two loudspeakers without the need for
tedious experimentation.

By placing the iQ 10/15 cabinets as shown in the diagram below, minimal dispersion
pattern overlap is achieved, guaranteeing an extraordinarily smooth transition.

6

40°

Dimensions

540.0

680.0

1116.0

7

!

SECUR ET – VEB Eyebolt

The Tannoy iQ 10/15 loudspeaker can be flown
with high quality VEB M10 eyebolts with collar to
BS4278:1984. The loudspeakers are equipped
with internal steel braces, which also double as
the flying points, and accept VEB M10 eyebolts.

To install the VEB M10 eyebolts remove the
original M10 counter sunk screws from the
locations you wish to install the VEB M10
eyebolts. Then replace these counter sunk M10
screws with the VEB M10 eyebolts. The kelping
brackets on the rear of the cabinet should only
be used for tilting the loudspeaker to the desired
angle.

Important: It is imperative for safety reasons
that two eyebolts linked to two independently
fixed straps are used per cabinet.
Never attempt to use formed eyebolts i.e.
formed from a steel rod and bent into an eye.