Tanita KD-191F Owner's Manual

Digital Scale

KD-191F

Instruction Manual

KD1917611(1)1008FA

2

◆Battery placement

<front> <back>

A

B

C

D

E

F

G

H

I

click

click

oz
g

oz
g

g version

oz
g

oz version

oz
g

oz
g

oz
g

oz
g

oz
g

Digital Scale Instruction Manual

Read this Instruction Manual carefully and keep it for future reference.

Name of parts

A Lock
B Clear cover
C Tray
D OFF button
E Display
F ON/TARE button
G Hook hanger
H Battery compartment

I Lid (Battery compartment)

How to use

Insert 2דAAA” “R03” or “24F”
batteries as indicated.

◆Hook Hanger

◆Inserting photographs or patterns etc.

Unlock the lock.

◆Weighing

Push ON/TARE.

◆Mode change

◆Automatic power off

◆Battery replacement

This scale can be hung on a hook for convenience.

When not using the
hook hanger, press it
into the scale until it
clicks for storage.

Remove the clear
cover.

If the weight of the item(s) exceeds the scale’s capacity, “EEEE” will appear on the display. Make sure you place item(s) in
the center of the tray.

Place the photograph
or pattern on the tray
in line with the guides
(points).

Place a bowl on
the tray.

Push ON/TARE. When a mode change is required, press ON/TARE and OFF buttons simultaneously, and then
select the proper mode. (for the g/oz version)

The scale is designed with an auto power-off function for energy efficiency. If the same reading is displayed for
more than 10 minutes the scale will automatically turn off.

If “Lo” appears in the display when attempting to weigh, replace the battery. (following previous instructions)

Align the clear cover
with the bottom of the
tray, and gently place
the clear cover back
on the tray.

Push ON/TARE to
subtract the weight of
the bowl.

Do not hang the scale in a location where it can swing, drop easily, or in an
otherwise unstable place. Doing so may damage the scale or cause injury due to
the scale colliding with another object or dropping from the hook. Also, do not
use a suction pad hook, double-sided tape hook, or weak magnet hook. Such
hooks may not be able to support the weight of the scale, causing it to fall.

Double-sided tape can be used to hold the
photograph or pattern in place.
To cover the entire surface of the tray with a
photograph or pattern, cut the photograph or
pattern to the same size as the paper that was
included with the scale. (max. 5 in × 4.7 in)

Lock the lock.

Place the material to
be weighed.

After removing the bowl, the display will show a
negative reading or “----”. Press the ON/TARE button
to return the display to “0”. Push OFF to turn off.

3

Trouble shooting Specification

• The power doesn’t turn on.

Insert 2 new size AAA (“R03” or “24F” ) batteries. Be sure that
the polarity of the batteries is set properly.

• “Err6” or “Err7” appears on the display.

The scale needs to be repaired. Please contact your retailer.

g/oz version

MODEL KD-191F

Capacity 3kg/105 oz

Minimum graduation 1g/0.05oz

Federal Communications
Commission and Canadian
ICES Notice

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules and Canadian ICES-003. These
limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:

l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

l Consult the dealer or an experienced radio or television technician

for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to
this device that are not expressly approved by Tanita Corporation may void the user’s
authority to operate the equipment.

1-14-2, Maeno-cho, Itabashi-ku
Tokyo, Japan
Tel : [phone]
Fax : [phone]

Level 8, vibgyor Towers, G Block, C-62
Bandra Kurla Complex, Bandra (East),
Mumbai 400051, INDIA
Tel : [phone]
Fax : [phone]

This scale is a precision instrument and must be used under certain conditions to
ensure accurate measurement. Please observe the following when using this
scale.

1. Never disassemble the unit.

2.

Use in a vibration-free location that is not exposed to direct sunlight.

3. The scale will not measure accurately in an environment subject to
large temperature and humidity changes. The unit takes approximately
two hours to adjust to such changes.

4. Keep chemicals off the scale. Wipe with a damp cloth from time to time.

5. Do not allow the scale to get wet.

6.

Do not use or store near heat sources(ovens, heaters, etc.).

7. When not used for a long time, remove the batteries and store the unit
in a dry, dust-free location.

8. Check and replace batteries before sending the unit for repair. If
repair is necessary, remove the batteries, repack the unit in the
original carton and protect with packing materials before shipment.

9. Do not leave objects on the weighing tray when the scale is not in use.

10. To avoid measurement error, do not measure while using equipment
that generates radio waves, such as mobile phones.

CAUTIONS

Copyright © 2010 TANITA Corporation. All Rights Reserved.