Tane ACCESSORIES User Manual
ACCESSORIES
Tie Wraps:TY-8
8 inch plastic Tie Wraps.
Sold in bags of 100.
Clear color only.
SPADE BITS
Ground Clamp Electrical Tape
ZINC with SS bolts
Brass Option Available
(Special Order Item)
Call for Min. Order Qty - Leadtime - Pricing
JAMBSTICK Pre-Wire Plugs
UL
Durable and Strong
65′ L× 3/4" W
Available:White or Black
Sold in sleeves of 10
Assorted sizes
Telephone Block
and 18" Cord
Type Part Number
RJ31 TJ-8
(8 wire block w/1 male jack)
RJ31-DUAL TJ-8 DUAL
(8 wire block w/2 male jacks)
The JambStick is used to ensure
proper drill angles for alarm wiring.
PPD-11
(Push Pull Disconnect)
This 2 wire connector features 2 holes used
to either mount the PPD-11 or to take the
pressure off the wires.
Available: White, Brown, Gray & Clear
STB-10 Plug= 3/8" Plug
SD-70 Plug= 3/4" Plug
reusable in Brown and White
EZ DUCT-IT
Low Voltage Wire Raceway
Sold in 5 packs. Each pack contains five
strips 3/8"×5/8"×5'. Total of 125'.
EZ DUCT-IT connectors sold separately
in 25 piece combo-packs.
61
ACCESSORIES
B-Connector
(DRY FILLED w/WHITE SLEEVE)
(SILICONE FILLED w/BLUE SLEEVE)
MATERIALS:
Outer Shell: Plastic Heat Shrink Tubing
Metal Housing: Brass
Inner Sleeve: Beryllium Copper plated with Bright Nickel
TANE WS-1
(Water Sensor with Leads)
Color: White
Size: 2 1/2" L × 1/2" W × 1/2" H
P/N TANE WS-1 WH Packed 5
Early water damage warning w/6' foot jacketed leads
Longer Leads available, 12V Operating @10 ma
Output 9V DC minimum
METAL
HOUSING
The WS-1 is a low cost reliable water sensor that works on 12VDC alarm
panels, on a 24 hr zone, open loop circuit.
The wiring works similar to a two wire smoke detector. You have a red +
and black - wire inside the cable jacket. The sensor draws a very small
current from the alarm panel’s 24 hr open loop circuit. When the terminals
get wet the internal transistor flip flops and locks down to close the circuit,
causing the alarm panel to send an alarm.
Note: If the Panel uses an EOL resistor, then 6VDC is the minimum
requirement.
Note: Not compatible with wireless transmitters.
Always test system for compatibility.
.67"(17)
1.02"(26)
Contact Resistance: 10 Milli Ohoms Initial
Dielectric: 1000 V
Strength of Joint: 9 lbs
PLASTIC
COVER
(5.7)
.224"
TANE BOX WSPR66A · 20 Watt Stainless Steel Box with Dual Tampers and Dual Tone Siren
Specifications:
·Tone Frequency:
Steady-1200HZ
Warble-800HZ to 1200HZ
1 second ramp cycle
·Operating Temp: -20°C to 60°C
·Dimensions:
5.67"H×5.63"W×4"D
(144mm×143mm×100mm)
·Color: Stainless Steel
AVAILABLE SPECIAL
ORDER ONLY
62
·Housing Material:
Stainless Steel with Dual Reed Tampers
·Speaker Type:
Voice coil impedance-8 ohm
·Rated Input Voltage: 12 VDC
·Range Voltage: 6-15VDC
·Sound Level: 115db/m
·Current Draw:
280mA @ 12VDC 8 ohm load
The TANE BOX WSPR66A Stainless-Steel Siren, can be fitted with a TANE LED STROBE
(sold separately), to provide visual as well as acoustic warnings and alerts.
Loading...