Tandberg Data Internal USB version User Manual

Power USB

Internal USB version

Installation Guide

1 Turn off the computer

2 Mount the RDX QUIKSTOR in the
PC.
be on the lower right. Secure the
unit by using the four mounting
screws provided.

3 Connect the USB and power cables
to the RDX QuikStor

4 Connect the USB cable to the host
PC mother board or USB HBA.
Pin 1 location is marked on the
cable connector with a triangle ( ).
Consult your motherboard/
HBA manual for the Pin 1 location
on the mating USB connector

The Eject/Power LED should

192

+5VDC
DATA­DATA+
GND
Key

©2007 RDX is a registered trademark of ProStor Systems, Inc.

Part No. 433822-01

PIN SIGNAL PIN SIGNAL
1 VCC 2 VCC

3 USB0- 4 USB1­5 USB0+ 6 USB1+
7 GND 8 GND
9 Key 10 USBOC

10

5 Turn on the computer

Warning:

• Connecting the USB Cable incorrectly
to the PC will result in damage.

• Verify PIN layout on the motherboard
versus cable connector PIN OUT.

Product Registration

Register this product at

www.tandbergdata.com/register

www.tandbergdata.com