Tamiya 53697 User guide

|TEM

53697

'I'I

Ll)^l

TAMTYA

SUPER

Tuned
lay-down

STOCK

motor best for sprint race use. Employs

MOTOR RZ

type brush

holder that

enables firm

contact with commutator, Motor features many

slits on its
Brush dampers increase
commutator,
which

tor cables

and

REPLACING

lf the

*Check

--packs,

surface and excels

and terminal heat sinks

is colored in red

are also adopted. Can be taken

re-built.

BRUSHES

brushes

worn

are

brushes after use of 5 - 10 full battery

in heat

adhesion of brush and

or black

shown, replace

as

dissipation,

to

match to mo-

Commutator

ruom

--+-.-

Brush

BATIO

GEAR

each of

them.

6.5-7.5:1

ORemove

springs. Then

move brushes from

the end

bell.

DISASSEMBLY

Remove

brush springs

the end

bell as

*Note

Brush

(red)

Loosen end bell screws

bell.

shown below,

polar§

heat sink

\

MOTOR AND

OF

first, then

direction of end bell.

End bell screw

Brush I

\sä

CHANGING ROTOR

pull

out brushes from

and remove end

End

apart

brush

bell

ROTATION

Make sure the

tion

of the motor is

The rotation

motor

when
gear
in

the

result

mance.

*Reverse
OWhen

the

re-

commutator as well.

one if the commutator

grcoved.

OThe

new brushes.

DIRECTION

rotation

direction

is counter-clockwise

viewed from

end. Running

opposite direction

the
the motor

in reduced

@Loosen

remove

procedure

the

replacing

motor should

Rotor

brushes, make

Motor

direc-

conect.

of the

pinion

will

perfor-

screws

brushes

as shown.

for installation.

Change the rotor

is badly

be warmed-up

can

and

sure to

inspect

to a new

burnt, scourcd,

after installing

or

*f,'N

l

Brush

screw

Brush

springs

,fl

End

bell scre#

CAUTIONS WITH HUNNING THE

OMake

bearings. Plastic

tation.

OContinuous

the motor

(tNever

gears

and rotating

motor

burn
ONever cover the
dissipation resulting in

motor

Olf

mance

OPeriodically disassemble, clean and maintain
tor after

(DUse

only

(tCommutator

ommended

(+

side

,/

Brush screw

sure to replace

running will damage the motor,

cool after

overload

out.

gets

will

deteriorate.

running it.

genuine

for cleaning. Replace the

-

or

and run

)

,/

plastic

bearings cannot endure motor ro-

each full

the motor.

parts

motor.

damaged or over-heats,

Cleaning Brush Set

battery

Make sure that all the

move smoothly to

Covering will hinder

damage.

Tamiya

spare

the motor without

MOTOR

bearings with

run.

prevent

parts.

(53487)

brush on one

load.

ball

Let

heat

perfor-

mo-

is rec-

Adiustment

*Number and thickness

used washers

cording to motor.

ftftffiffi**

ITEM

53697 Super

washers

5831

I Mercedes-Benz

Team Vodafone

Stock Motor BZ

may vary

CLK-DTM

AMc-Mercedes

(1

of

ac-

050332)