Talos Security DV700WICR User Manual
V1.0
DIMENSIONS
DV700WICR
111
60
136
TOP
SPECIFICATIONS
SPECIFICATION
CCD
Horizontal Resolution
Effective Pixels
Scanning System
Synchronization
Min.lllumination
S/N ratio
Video Output
Scanning Frequency
Electronic Shutter Speed
Sens-up
3D-DNR
White Balance
BLC
AGC
Day & Night
WDR
Motion Detection
Privacy Masking
Mirror
Sharpness
Lens
Power Source
Power Consumption
Operating Temperature
Operating Humidity
Dimensions (HxDmm)
Weight
FRONT
PALNTSC
1/3" SONY II CCD
Color - 600TV lines / B&W - 700TV lines
)V(285x)H(357)V(494x)H(867
2:1 Interlace
Internal
0.12Lux(15IRE:Sense-up OFF) F1.2 / 0.0002Lux(15IRE:Sense-up ON) F1.2
52 dB Min (AGC Off)
1Vp-p Composite 75Ω
15.734KHz(H)/ 59.94HZ (V) 15.625KHz (H) / 50Hz (V)
1/50 ~ 1/100,000sec1/60 ~ 1/100,000sec
OFF ~ x512
ON/OFF(OFF
ATW / ACW / MANUAL / PUSH
ON / OFF(WDR LEVEL, WEIGHT)
f = 2.8~12mm Aspheric AI Lens (F1.2) Standard
DC12V(±10%) / AC24V(±10%) Dual Power regulated
/ LOW / MIDDLE / HIGH)
ON / OFF
LOW / MIDDLE / HIGH / OFF
COLOR / BW / AUTO / EXT
ON / OFF
8Windows(Polygonal, 8Colors)
ON / OFF / V-FLIP, ROTATE
0 ~ 49
mm22~9 , mm6~6.2 noitpO
180mA Max.
-10°C ~ +50°C
30% ~ 90% RH
136 (Dia) x 111 (H)
875g
DV700WICR
User Manual
talossecurity.com
INSTALLATION
1
Fix the mount base onto the ceiling
or wall by the fixing screw and insert
the camera like the arrow direction.
Mount Base
Fixing Screw
Camera
Insert Point
2 3 4
SLIDEPIG 1
Fixing Point
PIG 2
After insert the camera body to the mount base
like the Fig1 and slide the camera body just like
the Fig2 to fix the camera onto the base.
Mount Base
Camera
Body
Fix the screw into screw hole in the mountbase by using the “L”wrench and tighten
the camera body onto the base.
“L” Wrench
Wrench Screw
Mount Base
Camera
Body
765
Cover
Ring
“L” Wrench
Unscrew the cover ring screw by
using the “L”wrench and open
the cover ring.
Camera
Gimbal
Gimbal Cap
Open the bubble cap and move the camera gimbal
to left, right and up, down to set the viewing direction.
After set the viewing direction, open the gimbal cap
like the arrow diection snd adjust the viewing angle.
OSD Controller
Video test Port
Set the desired OSD feature by using the OSD controller.
(Refer the SOD manual to set up the desired OSD)
in case of a installer has portable monitor, connect the
video jack to the video test port to set up the OSD.
Cover
Ring
“L” Wrench
Tighten the screw by using the “L”wrench
and complete the installation.
Loading...