Talk-a-Phone VOIP-500 Series Installation Manual
VOIP-500 Series Phone
Quick Installation Guide
QTY
Part Number
Description
1
VOIP-500***
VOIP-500 Series Phone
6
42867
#10-24 Tamper Resistant Screws
1
86392
Ferrite Core
Part Number
Description
42834d
#10 Tamper-resistant Screwdriver
42834b
#10 Tamper-resistant Bit
I. Introduction
This Quick Installation Guide provides instructions for installation of the VOIP-500 Series Phone. It is
recommended to read this instruction set completely before starting any installation.
II. Contents
Please ensure receipt of each of the included VOIP-500 Series Phone components:
Optional components include:
Page 1 of 6 Rev. 2/4/14
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
Figure 1 - Front view of a VOIP-500K
VOIP-500 Series Phone
Quick Installation Guide
III. Field Wiring Installation
1. Remove and set aside the VOIP-500 Series Phone assembly.
2. Remove the back box from the VOIP-500 Series Phone assembly by unfastening the six (6), #632 nuts and washers.
3. For PCB (Printed Circuit Board) wiring details, refer to Figure 2.
Figure 2 - Internal PCB (Printed Circuit Board) view
IV. Network Connectivity
The VOIP-500 Series Phone is equipped with two (2) Ethernet ports. The WAN Ethernet (PoE) port
should be used as the primary port for data communications. The WAN Ethernet port can be used to
power the phone via an IEEE 802.3af, Class 3 compliant PoE supply.
The VOIP-500 Series Phone has a layer 2 switchport labeled LAN Ethernet which can provide network
connectivity to an auxiliary device e.g. (IP Camera, Card Reader, etc). The LAN Ethernet port is a passthrough port and cannot be used to access the phone.
When installing the Network cable, it is essential to have a ferrite core (provided with the phone),
installed on to the cable as close as possible to the connector. Make sure the network cable is passed
twice through the ferrite core, forming a loop of not less than one (1) inch in diameter.
A cable with a rating of Cat5e or higher with an RJ45 connector is typical for all network cables.
Page 2 of 6 Rev. 2/4/14
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
Loading...