Talkaphone ETP-DMRK User Manual

ETP-DMRK Punch-Down Block Installation Instructions

Included with model ETP-DMRK are 11 RJ11 patch cords for connecting to the model EC-8 Consolidator.
The diagrams below show the connections for punching down and for connecting the DMRK and the
Consolidator.

Figure 1. Connections for Punching Down

Copyright 2009 Talk-A-Phone Co. All rights reserved.

Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Rev. 7/27/09

Phone [phone] • Fax [phone] • [e-mail] • www.talkaphone.com

All prices and specifications are subject to change without notice.

Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.

ETP-DMRK Punch-Down Block Installation Instructions

Figure 2. Mounting and Wiring Connections to EC-8

Instructions

1. All installations must comply with all Federal, State and Local Electrical and Building Codes. All
connections must test free of grounds, shorts and opens.

2. Place EC-8 Consolidator and ETP-DMRK Punch-Down Block on wall as shown in Figure 2 using
appropriate hardware for your application.

3. Attach all incoming lines from the ETP-Series phones to the ETP-DMRK Punch-Down Block
according to Figure 1.

4. Attach the eleven male/male RJ11 patch cords as shown in Figure 2.

Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Page 2 of 2

Phone [phone] • Fax [phone] • [e-mail] • www.talkaphone.com

All prices and specifications are subject to change without notice.

Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.

Copyright 2009 Talk-A-Phone Co. All rights reserved.