Takstar TS-8807 User Manual

TS-8807

TS-8807

User's Manual

UHF Wireless Microphones

GUANGDONG TAKSTAR ELECTRONIC CO., LTD.

Address: Xialiao Longxi Boluo Huizhou Guangdong China 516100

Tel: [phone]

Fax:[phone]

Website: www.takstar.com

Security:

4

• Do not apply any strong shock to it.

• Please place the batteries according to correct polarities. Take

out the batteries when not using it for a long time.

Annoucement:

• is a protected and registered trademark

• Product and contents described in the user manual are subject
to change without prior notice

1

Handheld Microphone:

1

2

3

4

(1) Wire-mesh cap and capsule:

wire-mesh cap protects the

capsule, eliminates “pop”

noise and avoids rolling

when laid flat.

(2) LCD display: indicate

frequency/channel and

battery power level.

(3) Power switch: press once,

it is on; press again, it is off.

(4) Microphone housing:

assemble wire-mesh capsule

and capsule on the top, with

batteries, PCB board inside,

and antenna at the rear.

Specification:

Transmitter

Power Supply: 2pcs 1.5V AA batteries

Playtime: 10hrs(depending on batteries)

Operating Range: 50m(depending on environment)

Operating Temperature: -20° -60°

Output Type: Independent Balanced and Unbalanced Outputs

3

2

Trouble Shooting:

Troules

Possible reasons

No RF signal on receiver

Frequency of transmitter and
receiver is not the same or out
of operating range

With RF signal, but no audio
signal

Microphone is not connected or
squelch level of receiver is too high

Background noise of audio
signal is too loud

Frequency deviation is too low;
output level of receiver is too low;
check if there is an interfering signal

Audio signal distortion

Frequency deviation is too high;
output level of receiver is too high

Operating distance is too
short, signal is not stable

Transmitter is set at low power;
squelch level of receiver is too
high; receiver antenna is wrong
placed; there is a strong
electro-magnetic interference

If there are other troubles, please contact us or your local
distributor or retailer. Please do not dismantle the products
as it will void warranty.

6

7

8

(6) Infra-red data

synchronization window:

send frequency signal

to transmitters by pressing

“SET” on receiver.

(7) Lock switch: if it is set at

“ON” position, the power

switch is locked and can

only be used for mute

function.

(8) Power adjusting switch:

choose high or low transmit

power.

5

(5) Battery compartment: put in

2pcs AA batteries.

1.How to use handheld microphone:

(1) Hold the middle part of microphone. If the hand is too close

to the wire mesh, the sound will be influenced; if the hand

is too close to the antenna at bottom, the operating distance

will be shortened.

(2) By changing the distance between microphone head and

mouth, the sound volume will be increased or reduced.

FCC WARNING

This device complies with Part 74 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.

NOTE 1: The manufacturer is not responsible for any changes or modifications not expressly
approved by the manufacturer for compliance, such modifications could void the user’s authority
to operate the equipment.

NOTE 2: This device complied with FCC radiation exposure limits as set forth for an uscontrolled
environment. This device should be installed and operated so that its antenna(s) are not co-located
or operating in conjunction with any other antenna or transmitter