TAKAYA TR3XM-SD01, TR3XM-SN02, TR3XM-SN01, TR3XM-SU01 User Manual

User’s Manual

TR3XM-SD01 TR3XM-SU01 TR3XM-SN01

TR3XM

-

SN02

Manual No.TDR-MNL-SX01-EN-101

TAKAYA RFID TR3 Series

Introduction

Thank you for purchasing a TR3XM-SD01／SU01／SN01 ／SN02RFID READER/WRITER.

Be sure to read this manual before using the product. After reading it, store the manual in a convenient place for future reference.

Manual No.TDR-MNL-SX01-EN-101

TAKAYA RFID TR3 Series

Regulations and Standards

FCC

This product is conform to the FCC standards.

FCC Rules (Federal Communications Commission) This product complies with Part 15 Subpart B and C of the FCC Rules. FCC ID : MK4TR3XM-SX01

FCC NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC WARNING

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Japan Radio Law

Equipment using high frequencies: Inductive Reading/Writing Communications Equipment Conforming standards: Inductive Reading/Writing Communications Equipment; Standard: ARIB STD-T82

RoHS is support

R

estriction of Hazardous Substances

Waste

Dispose of the Products as industrial waste.

Manual No.TDR-MNL-SX01-EN-101

TAKAYA RFID TR3 Series

Safety Precautions

The following symbols are used in this manual to indicate precautions that must be observed to ensure safe use of this product. The precautions provided here contain important safety information. Be sure to observe these precautions.

The following signal words are used in this manual.

Failure to comply with a WARNING may result in serious injury or death.

Failure to comply with a CAUTION may result in injury to the operator, or damage to the items involved.

Be sure to observe the following precautions to ensure safe use of the Products.

Decomposition of this product and cable, repair, remodeling, please strictly prohibited. There is the possibility of fire or electric shock injuries. This product is using the RFID reader writer radio equipment. Therefore, depending on where the applications you use may affect medical equipment. To minimize the impact of medical equipment for use, please observe the following countermeasure. The Japan Automatic Identification Systems Association (JAISA) guidelines are as follows: RFID antennas from implanted cardiac pacemakers or other medical devices please 22cm apart. We recommend that you paste "RFID sticker" at equipment.

Be sure to observe the following precautions to ensure safe use of the Products.

Installation and storage environment

1. Do not use the Products in sunlight.

2. Do not use the Products in environment of spray of water, oil or chemicals.

3. Do not use the Products in environments with flammable, explosive, or corrosive gasses.

4. Do not use the Products in environment of hot humid.

5. Do not use the Products in environment of vibration or shock.

6. Do not use the Products in environment of condensation.

7. Do not use the Products in environment of around the metal is covered.

8. Do not use the Products in environment of high temperature.

9. Do not use the Products in environment that has a device that generates magnetic field and shock voltage.

10. Do not use the Products in unstable place.

11. If there is failure, discontinue use immediately, please contact us or the distributor. Installation

1. Turn off the power before installation or removing.

2. The following effects may not work correctly. ･ Near 13.56MHz radio device ･ Near speakers , Inverter, motor and Plasma Display

3. The communication range may vary due to environment and conditions.

← RFID Sticker

Manual No.TDR-MNL-SX01-EN-101

TAKAYA RFID TR3 Series

Contents

1 Product Overview

................................

................................................................

......................................

............

...... 1111

1.1 Features .............................................................................................................................................. 1

2 Names of Parts and Functions

................................

................................................................

.....................................................

..........................................

..................... 3333

2.1 TR3XM-SD01 ..................................................................................................................................... 3

2.2 TR3XM-SU01 ..................................................................................................................................... 4

2.3 TR3XM-SN01 ..................................................................................................................................... 5

2.4 TR3XM-SN02 ..................................................................................................................................... 6

3 Setting and connection

................................

................................................................

................................ 7777

3.1 Setting ................................................................................................................................................. 7

3.1.1 DeskTop ........................................................................................................................................... 7

3.1.2 Wall Installation ................................................................................................................................ 7

3.2 Connection .......................................................................................................................................... 8

3.2.1 Attaching the Cable ........................................................................................................................... 8

4 Specifications

................................

................................................................

.............................................

..........................

............. 9999

4.1 TR3XM-SD01 ..................................................................................................................................... 9

4.2 TR3XM-SU01 ................................................................................................................................... 12

4.3 TR3XM-SN01 ................................................................................................................................... 15

4.4 TR3XM-SN02 ................................................................................................................................... 18

5 Accessories

................................

................................................................

..............................................

............................

.............. 21

2121

21

5.1 AC Adapter(TR3-PWR-5V-1) ............................................................................................................ 21

5.2 RS232C Cross-cable(CB-232C-2) ...................................................................................................... 22

5.3 USB Cable(GH-USB20/1.8M) ............................................................................................................ 23

5.4 RFID Sticker (SEL41400L) ............................................................................................................... 24

6 Maintenance

................................

................................................................

............................................

........................

............ 25

2525

25

Revision History

................................

................................................................

.............................................

..........................

............. 26

2626

26

Manual No.TDR-MNL-SX01-EN-101

1 Product Overview

1.1 Features

1

TAKAYA RFID TR3 Series

1 Product Overview

1.1 Features

This product uses the 13.56MHz frequency. This product is the electromagnetic induction type non-contact IC can read and write RFID tag data.

This Product is

the desktop reader choice to support various contactless applications such as electronic ID,

payment & public transportation schemes and to interact with NFC-enabled devices.

Model Name Host Device Interface TR3XM-SD01 RS232C TR3XM-SU01 USB TR3XM-SN01 TCP/IP TR3XM-SN02 TCP/IP

Antenna

TR3-A202

CPU Memory

RF-ASIC

TR3-C302(READER/WRITER Module)

Load Settings

Save Settings

Interface Module

TAKAYA TR3XM-SD01, TR3XM-SN02, TR3XM-SN01, TR3XM-SU01 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual