This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna
-Increase the separation betw een the equ ipm ent and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
RX-W1 Page 6
1. Pager Controller communicationForm
BAUD RATE
DATA BIT
PARITY
STOP BIT
2.Data Format
Start
BIT
(1bit)
3.RS-232-C Connector
9600BPS
8-BIT
NONE
1BIT
DATA
(8bit)
Stop
BIT
(1bit)
connected.
-Consult the dealer or an experienced radio/TV techn ic ian for help.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
The device is complies with part 15 of the FCC rules.
Operation is subject to the conditions that this device
does not cause harmful interference.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
RX-W1 Page 7
1. Pager Controller communicationForm
BAUD RATE
DATA BIT
PARITY
STOP BIT
2.Data Format
Start
BIT
(1bit)
3.RS-232-C Connector
9600BPS
8-BIT
NONE
1BIT
DATA
(8bit)
Stop
BIT
(1bit)
[1] Wetness Sensing System
(1)Overview
RX-W1 Page 8
1. Pager Controller communicationForm
BAUD RATE
DATA BIT
PARITY
STOP BIT
2.Data Format
Start
BIT
(1bit)
3.RS-232-C Connector
9600BPS
8-BIT
NONE
1BIT
DATA
(8bit)
Stop
BIT
(1bit)
‘—M‹@
‹Žº
’†Œp‹@
ŒÅ’èŒ^ŽóM‹@
—¾•êŽº
Œg‘ÑŒ^•\ Ž¦‹@
RX-W1 Page 9
1. Pager Controller communicationForm
BAUD RATE
DATA BIT
PARITY
STOP BIT
2.Data Format
Start
BIT
(1bit)
3.RS-232-C Connector
9600BPS
8-BIT
NONE
1BIT
DATA
(8bit)
Stop
BIT
(1bit)
This Wetness Sensing System is comprised with transmitters, transponders and
receivers, which inform caregivers o f sensing moisture in a diape r. Once wetness sensor
incorporated into diaper is aware of moisture, the transmitter including sensor puts out
the signal to the transponder and then to the receiver.
RX-W1 Page 10
1. Pager Controller communicationForm
BAUD RATE
DATA BIT
PARITY
STOP BIT
2.Data Format
Start
BIT
(1bit)
3.RS-232-C Connector
9600BPS
8-BIT
NONE
1BIT
DATA
(8bit)
Stop
BIT
(1bit)
Specifications
TRANSMITTER
Frequency 318.125M, 318.500M, 318.875M, 319. 250MHz
RF Output Power 2400V/m (67.6dBm) at 3 m
Frequency stability 0.001
Identification Area ID199, Individua l ID 199
Modulation system Variable reactance frequency modulation
Maximum Deviation 4 kHz
Power Source 3V (lithium battery CR2032)
Battery Life about 3 months ( dropped to 2.5V)
TRANSPONDER
Receive system Double-conversion superh et erodyne
Receiving Frequency 1 318.125M, 318.500M, 318.87 5M, 319. 250MHz
Receiving Frequency 2 314.500M~314.725MHz(25kHz step)
Sensitivity -113dBm for 12dB SINAD
Intermediate frequencies 1
st
21.7MHz
nd
450kHz
2
RX-W1 Page 11
1. Pager Controller communicationForm
BAUD RATE
DATA BIT
PARITY
STOP BIT
2.Data Format
Start
BIT
(1bit)
3.RS-232-C Connector
9600BPS
8-BIT
NONE
1BIT
DATA
(8bit)
Stop
BIT
(1bit)
Transmitt ing Frequency 314.500M~314.725MHz(25kHz step)
RF output power 2250V/m ( at 3 m )
Frequency stability 0.001
Modulation system Variable reactance frequency modulation
Maximum Deviation 4 kHz
Power supply requirement DC,AC9V 0.1A AC adaptor
Battery Life about 12 hours
RECEIVER
Receive system Double-conversion superh et erodyne
Receiving Frequency 1 318.125M, 318.500M, 318.87 5M, 319. 250MHz
Receiving Frequency 2 314.500M~314.725MHz(25kHz step)
Sensitivity -113dBm for 12dB SINAD
Intermediate frequencies 1
Frequency stability 0.001
Power supply requirement DC,AC9V 0.3A AC adaptor
Battery Life about 5 hours
st
21.7MHz
nd
2
450kHz
RX-W1 Page 12
Loading...
+ 27 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.