Takara Belmont apollo 2, Apollo 2 Icon User Manual

Thank you for choosing TAKARA BELMONT equipment.

Please read through this manual before assembling, installing or using the product to ensure safe and correct

use. This product is designed for commercial use in hairdressing and beauty salons. Do NOT use this product

for purposes other than the practices and services typically offered in these places.

Please keep this manual in a safe place for your future reference.

A PDF version of this manual can be downloaded at takarahairdressing.co.uk/downloads

Hydraulic Chair Manual

Apollo 2

Takara Belmont UK Ltd. Belmont House, 1 St. Andrews Way, Bow, London E3 3PA UNITED KINGDOM
takarahairdressing.co.uk T: [phone] E: [e-mail]

Assembling the U-shape and T-shape footrest

1. Locate and remove the attached screws from the underside of the chair top > 2. Attach the footrest to the position
where the screws were attached > 3. Tighten firmly > 4. Check that the footrest is attached securely.

1. Lock the chair using the foot pedal before lifting > 2. Carry the chair by holding it beneath the base > 3. Place
the chair down gently, being careful not to mark the floor > 4. Lift the chair carefully into its final position.

Assembling the chair top with the base

If the chair is used without the pin inserted firmly into the ditch,
the chair may become unstable resulting in damage or injury.

Safety precautions during installation

The chair must be installed on a flat and solid floor to ensure its stability.
At least two people should assist with carrying or moving a chair at all times.

ASSEMBLY AND INSTALLATION INSTRUCTIONS

Chair top

Chair base

Line up the ditch
to the pin and insert
the seat flange firmly.

• When assembling the footrest, do NOT use any screws other than those provided by Takara Belmont (located on the underside of chair top).

• Ensure all screws are tightened firmly. If the footrest is not attached to the chair firmly, it will become unstable and may result in damage or injury.

• Take care not to damage the upholstery or the chair parts during assembly: the chair top should be kept separate from the assemblage area.
> Please note, these drawings are for illustrative purposes only.

• Carefully position the chair base on a flat and solid floor.

• Present the chair top to the base, line up the ditch to the pin
and insert the seat flange firmly.

• Check that the chair top is attached securely.

• Do NOT apply any weight or stress to the armrest while carrying or
moving the chair to avoid breakage or deformation to the armrests.

• Do NOT hold and move the chair with somebody or something in the
seat.

• Take care when touching the underside of the chair top. Parts such
as fixing screws, fasteners, metal parts are attached here and careless
contact may result in injury.

• Carrying the chair by gripping the chair top is likely to cause the chair
base to slip off and may result in serious injury.



Seat front

Seat rear

Attachment
positions x4

Screws

U-shape
Footrest

U-shape
Footrest

T-shape
Footrest

Screws Screws

Seat rear

Seat front

Attachment
positions x4

Seat front

Attachment
positions x2

Seat rear