Taizhou Sanbrite SBT 10F User Manual

User Manual
Model: SBT-10F-RFREMOTE-W
Remote Functions
: Projector will turn on when button is pressed.
:Pressing this button will toggle between all laser
colors included with this product.
:This button will toggle between flashing and
steady depending on which laser or LED is enabled.
: Pressing this button will decrease the speed of
the flash mode.
: Pressing this button will increase the speed of the
flash mode
: Pressing this buttoncan select the desired LED
color included with this product.
: Pressing this button all LED colors will play automatically in circle.  : Pressing this button will stop the time mode. The projector will blink once to
confirm that timer mode is turned off.
: When projector is powered on and button is pressed, the projector will blink
three times. Projector will now be on a 6 hour timer. Projector will stay on for 6 hours and then turn off for 18 hours. This will repeat until 120VAC power is removed.
: When projectoris powered on and button is pressed, the projector will blink
three times. Projector will now be on a8 hour timer. Projector will stay on for 8 hours and then turn off for 16 hours. This will repeat until 120VAC power is remove
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Loading...