Taiyo A43949R Users Manual

MINI BIKE

OWNER’S MANUAL

Important! Please read your Owner’s Manual all the way through before operating your vehicle. Contains important information keep for future reference.

Safety First

• Adult supervision is recommended.

• Drive your vehicle in a safe area away from people, pets, cars, etc. Not in streets, not in dark, not in or near water!

• Don’t touch or try to pick up vehicle when it is in motion. Wait until it stops completely.

• Keep hair, fingers, face and loose clothing away from the wheels, spokes and tires while the vehicle is switched on or while the transmitter is operating.

Batteries Required

4 “AA” Alkaline (LR6) (or Rechargeable) Cells for vehicle and One 9-Volt (6LR61) Battery for Transmitter.
(Rechargeable batteries and charger not included.)

Battery Cautions

CAUTION: TO AVOID BATTERY LEAKAGE,HEAT GENERATION AND EXPLOSION

• Make sure the batteries are inserted correctly and follow the toy and battery manufacturer’s instructions.

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium, nickel-metal hydride, rechargeable alkaline) batteries.

• Remove weak or dead batteries from product.

• Ensure that the positive and negative connections are correct.

• After use, make sure to turn off the power switch and remove the battery.

• Do not allow the battery to be short-circuited. Also do not attempt to disassemble or heat the battery, or put it into flame.

More Important Battery Information

• Start with all new batteries and always replace ALL 4 vehicle batteries at the same time.

• Different type of batteries or new and used batteries are not to be mixed.

• Use only battery type(s) recommended.

• The vehicle is not to be connected to more than the recommended number of power supplies.

• The supply terminals are not to be short-circuited.

• Only batteries of the same or equivalent type as recommended are not to be used.

• Battery life may vary with the brand used.

• Exhausted batteries are to be removed from the toy.

• Do not recharge non-rechargeable batteries.

• Batteries are to be inserted with the correct polarity.

• Remove rechargeable batteries from the product before charging. Recharge batteries only under adult supervision and follow the battery and
charger manufacturers’ instructions.

• Keep vehicle and transmitter dry. If they get wet, immediately turn off power switch and remove batteries, wipe off excess moisture, and allow to air
dry for at least 24 hours.

• Dispose of batteries safely and properly.

• Batteries are to be replaced by an adult.

1. FEATURES

FRONT VIEW

Rider

Front Working
Suspension

REAR VIEW

ON/OFF Switch

Gyro Stabilizer
(Inside rear tire)

Rear Working
Suspension

Battery Holder
(Detachable)

TRANSMITTER

Left Stick
(Controls forward,
stop and braking)

2. BATTERY INSTALLATION

VEHICLE

Fig 1

Antenna

Right Stick
(Control Steering)

Fig 2

Side Stabilizer
(One each side)

Battery Latch

SETTING UP BIKE STAND

Bike Stand
(Please detach
while driving)

For Customers

The display stand can only be used when battery holder is installed.
Please insert the stand between rear of the battery holder and the vehicle.

Fig 3

Fig 4 Fig 5

1.Turn your vehicle over. Rotate the battery latch to release
the battery holder. Slide the holder toward the latch.

2.Lift the battery holder out of the vehicle.

3.Insert 4 AA alkaline (LR6) batteries into the battery holder,
with polarity ( / ) as shown on the holder.

4.Replace the battery holder in the vehicle.

5.Rotate the latch until it clicks shut, locking the holder in
place.

For Customers

Use only AA alkaline (LR6) batteries.

* Estimated run time for this vehicle: 60 minutes