Model No's: 50200058, 50200059, 50200060
Pump Sprayers
Instruction Manual
160809rev1
Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
Made in China
©2012 World Factory, Inc.
Distributed by:
World Factory, Inc.
Westlake, TX 76262
For warranty information, please refer to the back page of
this instruction manual.
Limited Warranty
World Factory, Inc. Products for Outdoor Use
World Factory, Inc. (Seller) warrants to the original Buyer only, that each Tahoe Product will be free
from defects in material and workmanship for a period of one (1) year from date of purchase.
SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED
WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH
ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE SELLER
WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY FROM
REPAIRS OR ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER
MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This
warranty does not apply to damage, heat-induced coloration changes, scratching or alteration due to
normal use or weathering. To make a claim under this Limited Warranty, you must return the complete
product with proof of purchase, transportation prepaid, to any World Factory, Inc. authorized service center.
Call 1-888-422-7800 or visit: www.ezreplacement.com for the location of the nearest authorized power
tool service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED
TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1) YEAR
FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR LOSS OF PROFITS,
ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such
provision shall not affect any other provision herein, this Limited Warranty shall be construed as if such
invalid and/or unenforceable provision had never been contained herein.
This warranty gives you special legal rights, and you may also have other rights which vary from state
to state.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all
prior agreements, arrangements, or understandings between the parties relating to product warranty.
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
For Manuals, Replacement Parts or Customer Service visit:
www.ezreplacement.com
1 6
A
PARTS LIST
PART # DESCRIPTION QUANTITY
A Tank & Pump Assembly 1
B Sprayer Wand 1
Parts Detail
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the trailer until they have been obtained and properly installed.
WARNING! Read and understand all instructions. Failure to follow all instructions listed below
may result in serious personal injury.
1. Always wear protective clothing, gloves, eye protection and respirator.
2. Always point nozzle in a safe direction.
3. Always release pressure and clean sprayer after use and before storage.
4. Never open bottle until pressure has been released
5. Do not put face or body over pump or pressure release valve when operating pump or valve.
6. Follow manufacturersí instructions for mixing, storage and safe disposal of product being used.
7. Use with Agricultural chemicals only. Do not use flammable, caustic or corrosive solutions.
8. Do not use in windy conditions
9. Keep out of reach of children.
GENERAL SAFETY RULES
B
5 2
ASSEMBLY INSTRUCTIONS
OPERATION
A
B
C
Figure 1
Attach the Wand (Figure 1)
1. Rotate wand nut (A) counter clockwise
to loosen.
2. Insert the wand shaft (B) through the nut and
into the handle (C) until it bottoms
3. Rotate wand nut clockwise to secure wand.
Filling the Tank (Figure 2)
1. With the pump handle (A) in the down position,
rotate counterclockwise to loosen.
Remove the pump.
Warning: Do not open bottle until pressure has
been released.
2. Fill tank according to the manufacturer's
instruction for the chemical being used.
Caution: Do not exceed "Max Fill" Line
3. Replace the pump. Rotate handle clockwise
to tighten.
Figure 2
A
Pressure
Release
Valve
Max. Fill
MAINTENANCE AND STORAGE
1. Empty and clean tank, pump and wand after each use with mild soap and water. Spray soap
and water solution through nozzle, hose and controller to remove all traces of chemicals.
2. Rinse thoroughly inside and out with clean water. Spray clean water through nozzle, hose
and controller.
3. Allow all parts to dry before storage. Store sprayer in a dry area out of reach of children.
4. Once a year, lubricate pump O-ring with petroleum jelly or water proof grease.
3 4
OPERATION (CONTINUED)
A
Figure 3
A
Figure 4
Pressurize the Tank (Figure 3)
1. To release the pump, rotate handle (A) to the
central "unlock" position and lift up.
Note: use caution not to loosen the pump
from the tank.
2. Pump the handle up and down approximately
20-30 times to pressurize the tank.
3. Lower the pump handle and rotate to the
"locked" position.
Spraying (Figure 4)
1. To start spraying, depress the thumb lever (A)
on the controller.
2. To stop spraying, release the thumb lever.
3. For continuous operation, depress and slide
the thumb lever forward to lock-on position.
The sprayer will continue to operate until the
thumb lever is pulled backward and released.
Nozzle Adjustment (Figure 5)
1. To adjust the spray pattern, rotate the nozzle (A):
Clockwise = Jet
Counterclockwise = Fine mist
Caution: Do not adjust the nozzle with the
thumb lever depressed. Do not
unscrew the nozzle completely.
A
Figure 5
Pressure Release (Figure 6)
1. To release pressure, lift up on the top of the
pressure release valve (A).
Figure 6
A
Loading...